Check whether the home.

A household at Residential retrofit site, Minneapolis MN wants to drop gas heat for a heat pump but does not know if the panel, ducts, and insulation can support it, the missing picture stalls the project and invites oversized quotes. Photograph the systems and panel and rank what a licensed pro needs to know.

Where

Residential retrofit site, Minneapolis MN · Open the map

Pay

$140 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

photo inventory (HVAC/water fuel+age, panel label, insulation) + GPS + panel amperage/spare-slot count + ranked heat-pump readiness list, all routed to licensed pros

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2027-07-07

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• tablet/clipboard with the readiness checklist
• camera
• tape measure
• flashlight (panel/attic/crawl)
• note on existing HVAC + water-heating fuel and age
• thermal/IR camera (optional, insulation scope)

Steps

1. 1. Confirm the address + scope with the owner/occupant and arrange access to the mechanical room, electrical panel, and attic/crawl. Observe-and-document only: no panel or HVAC work.
2. 2. Inventory existing space + water heating: fuel (gas/electric/oil/propane), system type + age, ducted vs. ductless suitability, and any combustion appliance present (for later decommission planning by a pro).
3. 3. Photograph the electrical panel label: main service amperage, panel make, and count of used vs. spare breaker slots; note obvious constraints (full panel, subpanels, aluminum branch wiring), as inputs for a licensed electrician's load calc, NOT a load calc yourself.
4. 4. Record the envelope/insulation baseline: attic/wall/floor insulation presence + approximate R-level where visible, and obvious air-leakage points; use IR imaging if available.
5. 5. Assemble a heat-pump readiness summary: what a conversion would likely require (panel capacity, dedicated circuit, ducting/ductless, envelope improvements) as a ranked readiness list, framed as inputs for licensed pros, not a design.
6. 6. Enter photos, GPS/address, the inventory, panel observations, insulation baseline, and the ranked readiness list; sign. Route panel/service and combustion-decommission questions to licensed pros.

What counts as done

• Photos of existing heating/water-heating systems with fuel + type + age
• Photo of the electrical panel label with service amperage + used/spare breaker slots recorded (observation, not a load calc)
• Insulation/air-sealing baseline (levels where visible, obvious leakage points)
• GPS / address confirm
• Ranked heat-pump readiness list framed as inputs for a licensed electrician / mechanical contractor

Proof is measured against these, not judged by taste.