OSHA Subpart T pre-demolition engineering-survey check — Row-house demolition corridor (Camden)

A Camden row-house demolition affects party walls shared with occupied homes, with no written engineering survey of adjacent structures, unverified utility shutoffs, and pre-demolition asbestos status unknown per OSHA Subpart T. Standard: OSHA 29 CFR 1926 Subpart T — Demolition (§§1926.850–860) Proof: photo from outside/safe positions per checklist section + GPS + Subpart T checklist + engineering-survey/utility/asbestos/access status + tiered findings routed to the competent person Method (OSHA 29 CFR 1926 Subpart T (Demolition, §§1926.850–860) pre-demolition engineering-survey verification — document-and-observe from outside or safe positions; documentation only, ~60-120 min): 1. Check in with the demolition contractor's competent person; confirm scope, don PPE, and confirm you observe-and-document only — you never enter a structurally compromised structure, never authorize demolition, and never disturb suspect materials. 2. Written engineering survey: verify a competent person's WRITTEN engineering survey of the structure AND affected adjacent structures exists on site (framing/floors/walls condition, unplanned-collapse possibility) and photograph its cover/signature page (§1926.850(a)); note bracing/shoring where fire or weathering has weakened members (§1926.850(b)). 3. Utilities: document shutoff/cap/control confirmation for electric, gas, water, steam, and sewer lines outside the building line, or the documented relocation/protection plan if a utility must stay live during the work, and that utility companies were notified (§1926.850(c–e)). 4. Hazardous materials: verify the hazardous-material determination is on file — including the NESHAP pre-demolition asbestos survey — and that any chemicals/gases/flammables in pipes or tanks were purged or controlled before work (§1926.850(f)); never sample or disturb suspect material yourself. 5. Access & falling-hazard protection: photograph protected employee entrances (sidewalk sheds/canopies where required), condition of stairways/passageways to be used, and barricading that keeps the public out of the demolition and debris-fall zones (§§1926.850(h–k)/.851). 6. Mechanical demolition (if underway or planned): from outside the exclusion zone, confirm no workers are inside the structure during ball/clamshell or machine demolition and the exclusion zone is barricaded (§1926.859). 7. For each finding, mark the condition against the Subpart T checklist item, assign a tier (stop-work / correct-before-proceed / monitor), and name the responsible competent person / engineer. 8. Enter photos, GPS/address, the checklist, and the tiered findings; sign. Route stop-work items to the competent person with a timestamp — never direct the demolition yourself. Equipment: hard hat + safety glasses + hi-vis vest + sturdy boots (site PPE), tablet/clipboard with the Subpart T pre-demolition checklist, camera with zoom (document structure condition from outside / safe positions), flashlight, copy request forms for the written engineering survey + utility shutoff confirmations Done when: Written engineering survey (structure + adjacent structures) verified on site and photographed, with bracing/shoring noted for weakened members; Utility shutoff/cap/control (or documented live-line protection plan) recorded for electric/gas/water/steam/sewer with utility notification; Hazardous-material determination incl. the NESHAP pre-demolition asbestos survey verified on file, purging/control documented; Access protection, public barricading, and (where applicable) the mechanical-demolition exclusion zone photographed; Every finding tiered with the competent person / engineer named; stop-work items routed with a timestamp

Where

Row-house demolition corridor, Camden, NJ

Pay

$135 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

photo from outside/safe positions per checklist section + GPS + Subpart T checklist + engineering-survey/utility/asbestos/access status + tiered findings routed to the competent person

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-08-07

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: OSHA 29 CFR 1926 Subpart T (Demolition, §§1926.850–860) pre-demolition engineering-survey verification — document-and-observe from outside or safe positions; documentation only

Bring

• hard hat + safety glasses + hi-vis vest + sturdy boots (site PPE)
• tablet/clipboard with the Subpart T pre-demolition checklist
• camera with zoom (document structure condition from outside / safe positions)
• flashlight
• copy request forms for the written engineering survey + utility shutoff confirmations

Steps

1. 1. Check in with the demolition contractor's competent person; confirm scope, don PPE, and confirm you observe-and-document only — you never enter a structurally compromised structure, never authorize demolition, and never disturb suspect materials.
2. 2. Written engineering survey: verify a competent person's WRITTEN engineering survey of the structure AND affected adjacent structures exists on site (framing/floors/walls condition, unplanned-collapse possibility) and photograph its cover/signature page (§1926.850(a)); note bracing/shoring where fire or weathering has weakened members (§1926.850(b)).
3. 3. Utilities: document shutoff/cap/control confirmation for electric, gas, water, steam, and sewer lines outside the building line, or the documented relocation/protection plan if a utility must stay live during the work, and that utility companies were notified (§1926.850(c–e)).
4. 4. Hazardous materials: verify the hazardous-material determination is on file — including the NESHAP pre-demolition asbestos survey — and that any chemicals/gases/flammables in pipes or tanks were purged or controlled before work (§1926.850(f)); never sample or disturb suspect material yourself.
5. 5. Access & falling-hazard protection: photograph protected employee entrances (sidewalk sheds/canopies where required), condition of stairways/passageways to be used, and barricading that keeps the public out of the demolition and debris-fall zones (§§1926.850(h–k)/.851).
6. 6. Mechanical demolition (if underway or planned): from outside the exclusion zone, confirm no workers are inside the structure during ball/clamshell or machine demolition and the exclusion zone is barricaded (§1926.859).
7. 7. For each finding, mark the condition against the Subpart T checklist item, assign a tier (stop-work / correct-before-proceed / monitor), and name the responsible competent person / engineer.
8. 8. Enter photos, GPS/address, the checklist, and the tiered findings; sign. Route stop-work items to the competent person with a timestamp — never direct the demolition yourself.

If it does not match the plan

• Demolition underway or imminent with NO written engineering survey on site -> STOP-WORK: document, keep clear, route to the competent person / a registered engineer; never authorize continuation.
• Any utility not confirmed shut off/capped/controlled (or no documented protection plan for a required live line) -> STOP-WORK for affected work; route to the competent person and the utility.
• No NESHAP asbestos survey on file, or suspect friable material observed -> STOP-WORK for disturbance work; route to a licensed asbestos inspector/abatement contractor; never sample or disturb it yourself.
• Workers inside the structure during mechanical demolition, or fire-damaged members unbraced where workers must pass -> STOP-WORK; keep clear; route to the competent person.
• Any entry into a structurally compromised structure, sampling, or demolition direction -> observe-and-document only; the competent person / engineer performs and approves these. Approval and correction stay human.

What counts as done

• Written engineering survey (structure + adjacent structures) verified on site and photographed, with bracing/shoring noted for weakened members
• Utility shutoff/cap/control (or documented live-line protection plan) recorded for electric/gas/water/steam/sewer with utility notification
• Hazardous-material determination incl. the NESHAP pre-demolition asbestos survey verified on file, purging/control documented
• Access protection, public barricading, and (where applicable) the mechanical-demolition exclusion zone photographed
• Every finding tiered with the competent person / engineer named; stop-work items routed with a timestamp

Proof is measured against these, not judged by taste.