Check the sanctuary air on Sunday morning at St. Jerome's Church (2026-07-17)

The sanctuary at St. Jerome's Church fills with parishioners for Sunday Mass, and the air quality has never been checked. A simple reading lets the congregation know the air they're breathing is healthy. Standard: ASHRAE 62.1 ventilation, CO2 <1000 ppm; LBC Health+Happiness. Proof: photo of the monitor in the sanctuary + CO2/PM2.5/RH log + GPS Method (ASHRAE 62.1 ventilation, CO2 <1000 ppm; LBC Health+Happiness.): 1. Set a CO2/PM2.5/RH monitor in the occupied sanctuary during Sunday Mass; photograph it in place. 2. Log CO2, PM2.5, relative humidity and temperature readings across the occupied period. 3. Note the visible ventilation (open doors/windows, HVAC running) during the service. 4. Compile the log and a short ventilation-improvement note for the parish office. Done when: photo of the monitor in the sanctuary + CO2/PM2.5/RH log + GPS

Where

Location on the packet

Pay

$80 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

photo of the monitor in the sanctuary + CO2/PM2.5/RH log + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-07-25

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: ASHRAE 62.1 + EPA IAQ / moisture baseline

Bring

• CO2 monitor
• PM2.5 monitor
• temp/RH meter
• moisture meter (mold/moisture scope)
• GPS/address
• camera

Steps

1. 1. Confirm the room/unit and address; coordinate to sample during normal occupancy where relevant.
2. 2. Photograph the space and any staining/damp/mold.
3. 3. Place the monitor in the occupied zone; log CO2 over >=1 occupied hour.
4. 4. Record PM2.5, temperature, and relative humidity.
5. 5. For moisture/mold scope, take moisture-meter readings at affected vs baseline areas and estimate visible mold area.
6. 6. Note ventilation type and any obvious deficiencies.
7. 7. Enter the logs, readings, extent notes, photos into the proof record; sign.

If it does not match the plan

• Carbon monoxide > 9 ppm sustained in an occupied space, or any audible CO alarm -> STOP: life-safety hazard. Evacuate, ventilate, and call the gas utility / fire department now. The agent escalates immediately, never sources the leak (NIOSH/ASHRAE CO).
• CO2 sustained > 2000 ppm in an occupied space -> flag acute under-ventilation: recommend increasing outdoor air and reducing occupancy immediately and report to the facility manager (well above the 1000 ppm ASHRAE 62.1 comfort flag).
• CO2 sustained > 1000 ppm -> flag under-ventilation vs ASHRAE 62.1.
• PM2.5 > 35 ug/m3 (24-hr, EPA NAAQS) -> flag elevated particulate; > 55 ug/m3 -> recommend occupants limit exposure / use filtration now.
• Visible mold > 10 sq ft OR active water intrusion -> document only, do not disturb; route to a licensed remediation pro (EPA mold guidance); occupants with respiratory symptoms routed to relocate.

What counts as done

• CO2 logged over >=1 occupied hour
• PM2.5, temperature, and RH recorded
• Moisture readings + visible-mold extent recorded (moisture scope)
• Timestamped photos + address confirm

Proof is measured against these, not judged by taste.