Anyone can start here · 400 block of Avondale Ave, Franklinton, Columbus OH 43215 (residential, "the Bottoms")
Log the basement moisture/flood-risk baseline of a home, Avondale Ave, Franklinton
Homes on Avondale Ave sit in Franklinton's historic low ground below the Scioto's pre-floodwall flood level; nobody has a simple, dated baseline of basement soil moisture, grade slope, and past waterline evidence to plan the resilience work from. Standard: FEMA floodplain + green-infrastructure siting screen; SDG 11.5 disaster resilience. Proof: Photos of the basement/crawlspace + any past-waterline evidence + Grade-slope photos at each problem spot + Moisture-reading log + one-page baseline sheet naming the follow-on jobs Method (FEMA floodplain + green-infrastructure siting screen; SDG 11.5 disaster resilience.): 1. Photograph the basement/crawlspace as found, noting any visible past-waterline stain, efflorescence, or standing-water evidence. 2. Walk the exterior grade and photograph any spot where soil slopes toward the foundation instead of away from it. 3. Probe basement-floor-perimeter soil moisture at 4+ points with a simple moisture meter and log the readings with a sketch map. 4. Compile the one-page baseline (grade issues, moisture readings, past-waterline evidence) naming the follow-on repair jobs in sequence (seal -> sump/backup -> vent). Done when: Photos of the basement/crawlspace + any past-waterline evidence + Grade-slope photos at each problem spot + Moisture-reading log + one-page baseline sheet naming the follow-on jobs
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: FEMA floodplain + green-infrastructure siting screen
Bring
- GPS phone
- tape/ruler for deposition depth
- metals field kit (if sediment screen in scope)
- boots + gloves
- camera
Steps
- 1. Confirm post-event conditions are safe; navigate to the site; record GPS.
- 2. Photograph deposited sediment / affected area.
- 3. Measure deposition depth at representative points.
- 4. If a sediment contaminant screen is in scope, run the metals field kit and record values.
- 5. Note debris, hazards, and the extent (sketch).
- 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign.
If it does not match the plan
- Unstable ground / submerged debris / contaminated water -> document from safe footing; do not enter.
- Elevated metals in deposited sediment -> flag before any reuse; recommend lab confirm.
What counts as done
- Deposition depth recorded at representative points
- Metals screen recorded (if in scope)
- Debris/hazard note + extent sketch
- GPS waypoint + timestamped photos
Proof is measured against these, not judged by taste.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.