Seal an active basement water-intrusion crack, Avondale Ave, Franklinton

The baseline on Avondale Ave found an active seep at a foundation crack; hydraulic-cement sealing it now is what keeps spring snowmelt and heavy-rain groundwater out of the living space before the next storm cycle. Standard: Interior basement/foundation crack sealing and hydraulic-cement patching to stop active water intrusion, per EPA moisture-control best practice. Proof: Before photo of the active crack/seep + Application photos of the hydraulic-cement patch + Cured, dry after photo from the same vantage Method (Interior basement/foundation crack sealing and hydraulic-cement patching to stop active water intrusion, per EPA moisture-control best practice.): 1. Photograph the active crack/seep and confirm the moisture source is groundwater, not a plumbing leak, before sealing. 2. Chase out and clean the crack per the hydraulic-cement product instructions. 3. Pack and finish the hydraulic cement, working from the ends of the crack toward any active drip point last. 4. Cure per product spec, then photograph the finished, dry patch and log the product/lot used. Done when: Before photo of the active crack/seep + Application photos of the hydraulic-cement patch + Cured, dry after photo from the same vantage

Where

400 block of Avondale Ave, Franklinton, Columbus OH 43215 (residential, "the Bottoms")

Pay

$85 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before photo of the active crack/seep + Application photos of the hydraulic-cement patch + Cured, dry after photo from the same vantage

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-01

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: Interior basement/foundation crack sealing and hydraulic-cement patching to stop active water intrusion, per EPA moisture-control best practice

Bring

• wire brush + shop vac (surface prep)
• hydraulic cement + masonry crack sealant
• trowel + mixing bucket + water
• moisture meter + camera

Steps

1. 1. ASSESS: photograph and map each crack/damp area with a moisture-meter reading; identify whether water is actively entering (active leak) or the area is just damp/stained.
2. 2. Clear loose material, dirt and any surface efflorescence from the crack with a wire brush and shop vac; dampen per the product's instructions.
3. 3. Pack an active leak with hydraulic cement (which sets against running water) or seal a dry crack with masonry sealant, per the product's method.
4. 4. Photograph the finished seal and record the moisture-meter reading at the same spot for comparison; advise the occupant to monitor after the next rain.

If it does not match the plan

• Visible active fungal growth, a musty odor, or a large area of sustained dampness beyond the crack itself -> STOP sealing and flag for a licensed moisture assessment; document only, never disturb any suspect growth.
• Water actively flowing (not just seeping) or a foundation crack wider than about 1/4 inch with visible movement -> route to a structural/waterproofing contractor before sealing.

What counts as done

• Crack/entry point fully packed or sealed with no gaps
• Before/after photos + moisture-meter readings at the same location
• Occupant informed of the follow-up rain-check to confirm the seal held

Proof is measured against these, not judged by taste.