Re-glaze a cracked window pane at a home on the 2100 block of Mattoon Avenue

A cracked single-pane window at this Washington Heights home is leaking conditioned air and a safety hazard in a home with kids, and it is a small glazing fix, not a full window swap. Standard: Re-glazing a cracked or broken window pane and re-puttying its sash, from the interior/ground level. Proof: before/after photos + GPS Method (Re-glazing a cracked or broken window pane and re-puttying its sash on an older rowhouse window, from the interior/ground level, ~45-90 min): 1. ASSESS: photograph the cracked/broken pane and measure the sash opening; confirm the work is reachable from inside or ground level (no exterior ladder work). 2. Remove the old, failed putty and any broken glass safely (gloves + safety glasses), and clean the sash rabbet. 3. Set the new pane on a thin bed of putty, secure with glazier's points, and apply and tool the finish putty bead to a clean, weathertight line. 4. Let the putty skin over per the product's cure time, then photograph the finished, weathertight pane from the same before vantage. Equipment: glazier's points + glazing putty/compound, putty knife + heat gun or scraper (old putty removal), replacement glass pane cut to size + gloves + safety glasses, camera Done when: Old broken glass and failed putty fully removed and safely disposed; New pane set, pointed and puttied to a clean, weathertight bead; Before/after photos from a matching vantage; Work done from interior/ground level only

Where

the 2100 block of Mattoon Avenue, Washington Heights, West Charlotte, Charlotte, NC 28216

Pay

$85 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

before/after photos + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-08-17

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: Re-glazing a cracked or broken window pane and re-puttying its sash on an older rowhouse window, from the interior/ground level

Bring

• glazier's points + glazing putty/compound
• putty knife + heat gun or scraper (old putty removal)
• replacement glass pane cut to size + gloves + safety glasses
• camera

Steps

1. 1. ASSESS: photograph the cracked/broken pane and measure the sash opening; confirm the work is reachable from inside or ground level (no exterior ladder work).
2. 2. Remove the old, failed putty and any broken glass safely (gloves + safety glasses), and clean the sash rabbet.
3. 3. Set the new pane on a thin bed of putty, secure with glazier's points, and apply and tool the finish putty bead to a clean, weathertight line.
4. 4. Let the putty skin over per the product's cure time, then photograph the finished, weathertight pane from the same before vantage.

If it does not match the plan

• Sash wood itself is rotted or the frame won't hold points/putty -> STOP; name the window-replacement job instead.
• Any exterior access above ground level required -> STOP; route to a job authored with proper fall-protection framing.

What counts as done

• Old broken glass and failed putty fully removed and safely disposed
• New pane set, pointed and puttied to a clean, weathertight bead
• Before/after photos from a matching vantage
• Work done from interior/ground level only

Proof is measured against these, not judged by taste.