intermediate work · 4600 Grant St, Globeville, Denver, CO 80216

Service the basement sump pump, Home on Grant St (4600 block), Globeville (2026-07-17)

Spring snowmelt and summer downpours push groundwater into this Grant St home's basement pit; a sump pump that isn't tested and cleared before the wet season is how a dry basement becomes a mold claim. Standard: Existing-home envelope + drainage maintenance (gutter/downspout clearing, weep-screed and foundation-vent clearance, minor exterior envelope-crack sealing, dryer-vent lint clearance) — the entry-rung DIY-safe maintenance that keeps a home dry, pest-excluded and ready for the LBC Energy/Water petal work above it. DOE Weatherization Assistance Program envelope-maintenance practice + CPSC dryer-vent fire-safety guidance. SDG 11.1 (adequate, safe housing). Proof: before/after photos + float-switch/discharge test video + GPS Method (Existing-home envelope + drainage maintenance (gutter/downspout clearing, weep-screed and foundation-vent clearance, minor exterior envelope-crack sealing, dryer-vent lint clearance) — the entry-rung DIY-safe maintenance that keeps a home dry, pest-excluded and ready for the LBC Energy/Water petal work above it. DOE Weatherization Assistance Program envelope-maintenance practice + CPSC dryer-vent fire-safety guidance. SDG 11.1 (adequate, safe housing).): 1. Photograph the sump pit, pump and discharge line as found; confirm the pump plugs into an existing GFCI-protected outlet only. 2. Clear debris and sediment from the pit; test the float switch by raising it by hand and confirming the pump cycles. 3. Clean or replace the check valve on the discharge line if it's stuck or missing, and confirm the discharge line routes water well away from the foundation. 4. Pour a test bucket into the pit, confirm the pump cycles and clears it, and photograph the finished, tested setup. Done when: before/after photos + float-switch/discharge test video + GPS

Where: 4600 Grant St, Globeville, Denver, CO 80216
Pay: $110 proposed
This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.
Proof: before/after photos + float-switch/discharge test video + GPS
This is exactly what gets it approved. Nothing settles without it.
Level: intermediate
Open until: 2027-07-18

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 30–120 minutes. Method of record: Existing-home envelope + drainage maintenance (gutter/downspout clearing, weep-screed and foundation-vent clearance, minor exterior envelope-crack sealing, dryer-vent lint clearance) — the entry-rung DIY-safe maintenance that keeps a home dry, pest-excluded and ready for the LBC Energy/Water petal work above it. DOE Weatherization Assistance Program envelope-maintenance practice + CPSC dryer-vent fire-safety guidance. SDG 11.1 (adequate, safe housing). assess->clear/patch->verify

Bring

ladder rated for gutter-line access (or a ground-level gutter-cleaning wand) + gloves
garden hose or gutter scoop + bucket for downspout flush
exterior-grade caulk/sealant + putty knife for minor envelope-crack sealing
flexible dryer-vent brush kit + shop vacuum for lint clearance
camera + GPS + tape measure

Steps

1. ASSESS: photograph each gutter run, downspout outlet, foundation weep screed/vent, exterior crack, and dryer-vent termination as found (debris, growth, buried screed, crack width, lint buildup).
2. Clear gutters and downspouts by hand or scoop, working from a stable ladder or ground-level tool; flush each downspout with water and redirect any outlet that discharges against the foundation to daylight at least 3 ft away.
3. Clear vegetation, mulch and debris from weep screeds and foundation vents so the wall assembly can drain and breathe; clean and prep any minor exterior envelope crack (non-structural, hairline to 1/4 in) and seal it with an exterior-grade sealant matched to the substrate.
4. Clear the dryer-vent duct run with a flexible brush kit from both the machine end and the exterior termination, and vacuum out the accumulated lint.
5. VERIFY: photograph each item from the matching before-vantage, pour a test cup of water down each cleared downspout to confirm flow, and confirm the dryer-vent damper opens and closes freely.

If it does not match the plan

Crack is wider than 1/4 in, stepped, or shows active movement -> STOP, do not seal, route to a licensed structural inspector.
Gutter-line access requires a ladder above 2 stories or a steep/wet roof -> route to a licensed/insured gutter contractor instead of DIY.
Weep screed or vent is buried under hardscape/grade that would require digging to expose -> document and route to a contractor rather than disturbing it.

What counts as done

Before/after photo pairs for every gutter run, weep screed/vent, crack and vent termination worked
Downspout water-flow test showing clear discharge routed away from the foundation
Dryer-vent damper opens/closes freely after clearing, with a lint-removal photo
No structural crack (wider than 1/4 in, stepped, or actively growing) sealed over — those route to a licensed inspector instead

Proof is measured against these, not judged by taste.

Claim it on the board

Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.

Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.