Apply compost to rebuild soil on the parcel's worst zone, Lucerne Valley

The baseline's poorest zone has almost no organic matter left; a measured compost application (NRCS 336 pattern) is the fastest honest way to restart its soil biology and water-holding capacity. Standard: USDA NRCS soil health — CPS 340 (cover crops) + CPS 336 (soil carbon amendment) conservation practice standards. Proof: application record + before/after photos + depth checks at 3+ points + GPS Method (USDA NRCS soil health — CPS 340 (cover crops) + CPS 336 (soil carbon amendment) conservation practice standards.): 1. Photograph the application zone as found and confirm the rate and finished-compost quality documentation against the plan. 2. Calibrate the rate with a bucket-per-area test. 3. Spread compost evenly across the zone, keeping material out of any wash or drainage line. 4. Leave surface-applied or rake in exactly per the plan. 5. Photograph the finished application with depth-check photos (ruler) at 3+ points and log source, quantity, rate and date. Done when: application record + before/after photos + depth checks at 3+ points + GPS

Where

High-desert parcel area near Camp Rock Rd, Lucerne Valley, CA 92356

Pay

$85 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

application record + before/after photos + depth checks at 3+ points + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-01

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 90–360 minutes. Method of record: Compost application per NRCS CPS 336 / CDFA Healthy Soils quantification (rate, quality, incorporation for the site) — finished compost only; assess→apply→verify

Bring

• finished compost meeting the quality spec (temperature-cured; STA/US Composting Council tested where available)
• spreader, wheelbarrow + rakes/shovels at garden scale
• camera + GPS + tape/bucket for rate calibration
• gloves + dust mask for dry material handling

Steps

1. 1. ASSESS: photograph the application area as found, record GPS boundary and area, and confirm the application rate (tons/acre or inches of depth) and compost quality documentation against the plan.
2. 2. Calibrate the rate (bucket-per-area or spreader pass test) so the applied depth matches the plan.
3. 3. Apply compost evenly across the area; keep material out of waterways, drains, and off pavement (sweep any spill back onto soil).
4. 4. Incorporate or leave surface-applied exactly per the plan (no-till surface application is valid under CPS 336).
5. 5. VERIFY: photograph the finished application from matching vantage + a depth-check photo (ruler in the applied layer) at ≥3 points; log source, quantity, rate, and date as the application record.

If it does not match the plan

• Compost not finished (hot, ammonia smell, recognizable feedstock) -> reject the load; immature compost harms the soil it should build.
• Rain forecast that would wash material to a drain before incorporation -> delay application.
• Application area drains directly to a waterway with no buffer -> route to the conservation planner for a setback plan first.

What counts as done

• Application record complete: source, quality doc, quantity, rate, area, GPS, date
• Depth-check photos at ≥3 points match the planned rate
• No compost in gutters/drains/waterways (site-perimeter photo)

Proof is measured against these, not judged by taste.