Build rock check-dams and rain basins to slow the parcel's runoff, Lucerne Valley

The parcel's rare cloudbursts leave in minutes, cutting rills and taking soil with them; small rock check-dams and microcatchment basins turn those minutes of water into days of soak — the desert's whole water budget is in the slowing. Standard: UN SDG 6 — clean water (6.6 protect and restore water-related ecosystems). Proof: before/after photos per structure + GPS structure log + water-holding photo Method (UN SDG 6 — clean water (6.6 protect and restore water-related ecosystems).): 1. Photograph the rills and runoff lines after inspecting the drainage pattern; mark check-dam and basin sites with flags. 2. Build one-rock-high check dams across rills (single course, keyed into the bed, never taller than one rock). 3. Dig crescent microcatchment basins on contour above planting spots; berm the downhill lip with the spoil. 4. Photograph each structure from matching vantage and log GPS per structure. 5. After the next rain (or a poured bucket test), photograph water held behind representative structures. Done when: before/after photos per structure + GPS structure log + water-holding photo

Where

High-desert parcel area near Camp Rock Rd, Lucerne Valley, CA 92356

Pay

$95 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

before/after photos per structure + GPS structure log + water-holding photo

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-01

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: SDG 6.1/6.3 (safe water, reduce pollution) — sample or inspect to a fixed protocol so results compare across sites and dates

Bring

• test kit for named analytes
• clean sample bottles + labels
• nitrile gloves
• thermometer
• camera + phone with GPS

Steps

1. Photograph the site BEFORE with GPS on and a legible timestamp; confirm you are inside the posting radius.
2. 2. Confirm the sampling point matches the posting; record the waypoint.
3. 3. Photograph the source with a legible timestamp.
4. 4. Label the bottle BEFORE filling: site, date, time.
5. 5. Fill without touching the bottle interior; cap immediately.
6. 6. Run each test per kit instructions, waiting the exact development time.
7. 7. Record every reading with its unit and the water temperature.
8. 8. Record all results, GPS, and time into the proof record and sign it.

If it does not match the plan

• Reading exceeds the named health threshold -> tag the exceedance and advise certified-lab confirmation; do not tell anyone the water is safe.
• Kit is past its expiry -> results are not evidence; stop.
• Development time missed -> rerun that test; a late read is not a result.
• Source is visibly contaminated or inaccessible -> document and do not sample.

What counts as done

• Before and after photos from the same position, GPS inside the posting radius, timestamps legible
• Bottle labelled before filling, visible in a photo
• Every reading recorded with its unit
• Water temperature recorded
• Kit expiry confirmed in date
• Exceedances tagged with a lab-confirmation recommendation

Proof is measured against these, not judged by taste.