Repair the low roofline gutter run on an invited Camden rowhouse

Many Camden rowhouses have sagging or split gutter runs at the porch roofline that dump rain down the front wall, rotting lintels and soaking party walls. Once the ground outlets are clear, the next rung is fixing the gutter itself so water actually reaches the downspout. Standard: Older-housing envelope maintenance practice per HUD Healthy Homes; SDG 11. Proof: Before/after photos of the gutter run plus a water-flow test photo Method (Older-housing envelope maintenance practice per HUD Healthy Homes; SDG 11.): 1. Confirm the host invitation and inspect the porch-level gutter run from a stable step position no higher than six feet. 2. Re-hang sagging sections with new hangers so the run slopes toward the downspout. 3. Seal split seams and end caps with gutter sealant. 4. Flush the run with a bucket of water and confirm flow to the outlet. 5. Photograph the repaired run and the water test with GPS and date. Done when: Before/after photos of the gutter run plus a water-flow test photo

Where

Invited rowhouses, Cramer Hill, Camden, NJ 08105

Pay

$85 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos of the gutter run plus a water-flow test photo

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-01

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 90–180 minutes. Method of record: Second-story/roofline gutter cleaning and repair on a rowhouse — credentialed crew, anchored fall protection, per OSHA 1926 Subpart M fall-protection practice

Bring

• anchored fall-arrest harness + ladder rated for the height (site PPE)
• gutter scoop/trowel + bucket
• gutter sealant or replacement hanger/section as needed
• camera

Steps

1. 1. ASSESS: set up and inspect the ladder/anchor point per OSHA 1926 Subpart M before any climb; photograph the gutter's condition (sag, disconnected hangers, leaks) from the ground first.
2. 2. With fall protection anchored, clear debris from the gutter trough and downspout head; check hanger spacing and pitch toward the downspout.
3. 3. Reseal joints, replace failed hangers/sections, and re-pitch the run so it drains fully to the downspout.
4. 4. Flow-test with water from the roof edge and confirm no leaks at seams/joints; photograph the completed run.
5. 5. Descend, stow equipment, and photograph the finished gutter from the ground vantage matching the before photo.

If it does not match the plan

• No anchored fall-protection point available or ladder not rated for the height -> STOP work, do not climb.
• Rotted fascia/soffit found behind the gutter -> flag to the owner and route to a licensed contractor before remounting hangers.

What counts as done

• Anchored fall protection used for the full duration of elevated work
• Gutter trough clear, properly pitched and draining fully to the downspout
• Flow-test photo/video showing no leaks at seams or joints
• Before/after ground-vantage photos

Proof is measured against these, not judged by taste.