Seal the drafty doors at Pilgrim Rest Baptist Church

Big church doors that see hundreds of hands a week wear out their seals fast, and in Phoenix every gap leaks expensive cooled air into 110-degree afternoons. Fresh weatherstripping and door sweeps on the sanctuary and hall doors is a half-day job that pays the congregation back all summer. Standard: ENERGY STAR for Congregations air-sealing guidance; SDG 7. Proof: Before/after photos per door + door count Method (ENERGY STAR for Congregations air-sealing guidance; SDG 7.): 1. Confirm the door list from the energy walk with the facilities host. 2. Remove worn weatherstripping and clean the door frames. 3. Fit new compression weatherstripping to each frame and a sweep to each door bottom. 4. Open and close each door to confirm smooth latch and no daylight gaps. 5. Photograph each sealed door before and after with date and GPS. Done when: Before/after photos per door + door count

Where

Pilgrim Rest Baptist Church, 1401 E Jefferson St, Phoenix, AZ 85034

Pay

$200 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos per door + door count

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-02

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: ASHRAE Level 1 energy audit

Bring

• tablet/clipboard
• tape measure
• light meter (lighting scope)
• clamp thermometer (refrigeration scope)
• 12-month utility bills
• camera
• ladder + spotter (high fixtures)

Steps

1. 1. Confirm the address; arrange a staff escort for mechanical/back-of-house.
2. 2. Photograph HVAC, lighting, envelope, and any in-scope systems.
3. 3. Inventory systems: HVAC type + age; lighting fixture count/type/wattage; refrigeration units; envelope condition.
4. 4. Summarize 12 months of utility use (kWh / therms) from the bills.
5. 5. Take the in-scope measurements (light levels, unit temperatures, seal condition).
6. 6. Rank no-cost/low-cost measures, then capital measures, with rough savings logic.
7. 7. Enter inventory, measurements, utility summary, photos, and the ranked measure list; sign.

If it does not match the plan

• Knob-and-tube, ungrounded or overheated wiring, scorched outlets, or a hot electrical panel -> STOP: do not operate the circuit; route to a licensed electrician and restrict use (NEC / fire hazard).
• Gas odor, or a combustion appliance with absent/blocked venting (backdrafting / CO risk) -> STOP: evacuate, ventilate, call the gas utility. The agent escalates, never relights or adjusts gas.
• Any live-electrical/gas hazard -> document, do not touch, flag for a licensed pro.
• Refrigeration unit out of food-safe range -> flag as both energy and food-safety risk.
• Suspected asbestos/lead in materials -> flag and stop.

What counts as done

• System inventory complete for the in-scope equipment
• 12-month utility use summary recorded
• In-scope measurements recorded with units
• Ranked no-cost/low-cost + capital measure list produced

Proof is measured against these, not judged by taste.