Build a compost bin for the church kitchen's food scraps at Pilgrim Rest

A congregation that serves hundreds of meals sends bags of vegetable scraps to the landfill every week, where they rot into methane. A simple three-bay pallet compost bin behind the fellowship hall turns those scraps into soil for a future church garden and keeps them out of the trash. Standard: EPA community composting guidance; SDG 12 Responsible Consumption and SDG 2 Zero Hunger. Proof: Photos of built bin + signage + first layered load Method (EPA community composting guidance; SDG 12 Responsible Consumption and SDG 2 Zero Hunger.): 1. Agree the bin site with the facilities host, on ground with drainage and away from doors. 2. Assemble a two- or three-bay bin from pallets or wire fencing, staked square and level. 3. Post a simple what-goes-in sign (vegetable scraps and coffee yes; meat and dairy no). 4. Start the pile with a first load of scraps layered with dry leaves or shredded paper. 5. Photograph the finished bin, sign, and first layer with date and GPS. Done when: Photos of built bin + signage + first layered load

Where

Pilgrim Rest Baptist Church grounds, 1401 E Jefferson St, Phoenix, AZ 85034

Pay

$220 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Photos of built bin + signage + first layered load

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-02

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: USDA/SARE sustainable vegetable production + Cooperative Extension Master Gardener practices; People's Garden bed establishment. Hand-tool, DIY-safe food growing on tested/known-clean soil or raised beds.

Bring

• GPS-capable phone
• camera
• garden fork/broadfork + hand trowel
• finished compost + rake
• seeds or transplants (labeled)
• mulch (straw/leaf)
• watering can or hose

Steps

1. 1. Confirm the bed location inside the posting radius; record the GPS waypoint and photograph the bed before work.
2. 2. Clear weeds and debris; loosen the top 8-12 inches with a fork/broadfork without inverting the soil profile.
3. 3. Spread 1-2 inches of finished compost and rake the bed level.
4. 4. Sow seeds to the depth/spacing on the packet, or set transplants at their correct depth, in labeled rows.
5. 5. Water in gently to settle the soil around seeds/roots.
6. 6. Apply a light straw/leaf mulch between rows to hold moisture, keeping it off seedling stems.
7. 7. Record the crop plan, spacing, and a watering/harvest cadence for the next visit.
8. 8. Enter crop list, GPS, before/after photos, and the care cadence into the proof record; sign.

If it does not match the plan

• Soil is untested near a pre-1978 structure, old orchard, or roadway (possible lead/contaminant) -> do not plant edibles in-ground; use a raised bed with clean imported soil and flag for a soil test.
• Out-of-season crop or a hard frost in the forecast -> adjust the crop choice or protect with cover; do not sow into a predictable loss.
• Signs of active pest/disease on transplants -> reject the affected stock and note it; never introduce a known infestation to the bed.

What counts as done

• GPS waypoint recorded inside the posting radius
• Before and after photos of the planted bed
• Crops sown/transplanted at packet-correct depth and spacing, in labeled rows
• Bed watered in and mulched, with a watering/harvest cadence recorded

Proof is measured against these, not judged by taste.