Restore the sidewalk tree pits around the parish block in Mayfair (2026-07-19)

The sidewalks around the parish carry Mayfair's processions, school runs, and Sunday crowds under a canopy thinner than almost anywhere in San Jose — and the tree pits on the block are compacted and bare. Restored, mulched, watered pits keep shade over the neighborhood's most-walked block and finish the campus series where the community actually gathers. Standard: San Jose street-tree maintenance standards (Our City Forest practice area); SDG 11 (Sustainable Cities and Communities). Proof: Before/after photos of each restored pit Method (San Jose street-tree maintenance standards (Our City Forest practice area); SDG 11 (Sustainable Cities and Communities).): 1. Adopt the tree pits on the parish block and clear trash, weeds, and debris by hand. 2. Loosen surface soil gently, avoiding roots. 3. Mulch 3 inches deep, clear of trunks. 4. Water each living tree slowly with 10 or more gallons. 5. Photograph each pit before and after with the block context. Done when: Before/after photos of each restored pit

Where

Sidewalk tree pits on the blocks around E San Antonio Street and King Road, San Jose, CA 95116

Pay

$200 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos of each restored pit

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-10-19

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: Street-tree pit restoration per ISA arboriculture BMPs + municipal urban-forestry standards (de-compact, weed, amend, mulch, water) — hand tools only, no root cutting; assess→restore→verify

Bring

• hand cultivator/garden fork + weeding tools (hand tools only)
• arborist wood-chip mulch (3-inch layer, keep off the trunk flare)
• watering container(s) / water source access
• camera + measuring tape

Steps

1. 1. ASSESS: photograph the tree pit as found; note compaction, weeds, trash, girdling material (wire, cords, mats), soil level against the trunk flare, and visible trunk damage.
2. 2. Clear trash and weeds by hand; remove any girdling material from the trunk wherever it lifts free without cutting bark.
3. 3. De-compact the top 2–3 inches of pit soil with a hand fork WITHOUT cutting roots ≥1 inch — work around them; level soil away from the trunk flare so the flare is visible.
4. 4. Apply a 3-inch arborist-chip mulch ring keeping a 3-inch gap at the trunk (no volcano mulching), and water thoroughly (15–20 gallons for a young tree).
5. 5. VERIFY: photograph the finished pit from the matching vantage (flare visible, mulch ring correct, pit weed-free) and log the watering; flag dead/hazard limbs or trunk wounds to the municipal urban-forestry line — never prune above shoulder height yourself.

If it does not match the plan

• Roots ≥1 inch in the work zone -> work around them; never cut structural roots.
• Dead/hanging limbs, major trunk wounds, or a leaning tree -> photograph and report to urban forestry; no pruning above shoulder height, no ladder work.
• Suspected utility conflict in the pit (exposed line, meter box) -> stop digging and report.

What counts as done

• Before/after photos from matching vantage; trunk flare visible, no mulch against bark
• Pit de-compacted and weed/trash-free; girdling material removed and photographed
• Watering completed and logged (volume noted)

Proof is measured against these, not judged by taste.