Add a flood vent so a Pajaro home's foundation can breathe

The Pajaro River levee sits close to town, and the next high flow could push water against foundation walls again. A code-style flood vent lets water pass through the crawl space instead of building pressure against the walls, which is one of the cheapest things a homeowner can do before the next storm season. Standard: FEMA NFIP flood-vent requirements (44 CFR 60.3); local floodplain building practice — SDG 11. Proof: Photo of the installed, operable flood vent Method (FEMA NFIP flood-vent requirements (44 CFR 60.3); local floodplain building practice — SDG 11.): 1. Confirm the vent location and size with the host and any posted floodplain requirement. 2. Cut the opening per the vent manufacturer's template. 3. Install and fasten the vent per its instructions. 4. Check that the vent operates freely. 5. Photograph the installed vent with GPS and date. Done when: Photo of the installed, operable flood vent

Where

Invited home near Salinas Rd, Pajaro, CA 95076

Pay

$300 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Photo of the installed, operable flood vent

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-03

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: FEMA floodplain + green-infrastructure siting screen

Bring

• GPS phone
• tape/ruler for deposition depth
• metals field kit (if sediment screen in scope)
• boots + gloves
• camera

Steps

1. 1. Confirm post-event conditions are safe; navigate to the site; record GPS.
2. 2. Photograph deposited sediment / affected area.
3. 3. Measure deposition depth at representative points.
4. 4. If a sediment contaminant screen is in scope, run the metals field kit and record values.
5. 5. Note debris, hazards, and the extent (sketch).
6. 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign.

If it does not match the plan

• Unstable ground / submerged debris / contaminated water -> document from safe footing; do not enter.
• Elevated metals in deposited sediment -> flag before any reuse; recommend lab confirm.

What counts as done

• Deposition depth recorded at representative points
• Metals screen recorded (if in scope)
• Debris/hazard note + extent sketch
• GPS waypoint + timestamped photos

Proof is measured against these, not judged by taste.