Haul storm-downed yard debris from an invited Pajaro lot

Storm winds and high water left broken branches, downed fencing, and yard debris piled on lots around Pajaro that families haven't had the truck or the hands to clear. A simple haul to the transfer station opens the yard back up and removes fuel for pests before summer. Standard: County code-compliance debris-removal practice; CalRecycle disposal guidance — SDG 11. Proof: Before/after photos plus the disposal receipt Method (County code-compliance debris-removal practice; CalRecycle disposal guidance — SDG 11.): 1. Photograph the debris pile with the owner's invitation confirmed. 2. Bag or bundle yard debris and load it with a partner. 3. Leave any drums, unknown containers, or sharp metal untouched and flag them. 4. Haul the load to the county transfer facility and keep the receipt. 5. Photograph the cleared lot with GPS and date, attach the receipt. Done when: Before/after photos plus the disposal receipt

Where

Invited lot near Salinas Rd & Pajaro Blvd, Pajaro, CA 95076

Pay

$220 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos plus the disposal receipt

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-03

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: FEMA floodplain + green-infrastructure siting screen

Bring

• GPS phone
• tape/ruler for deposition depth
• metals field kit (if sediment screen in scope)
• boots + gloves
• camera

Steps

1. 1. Confirm post-event conditions are safe; navigate to the site; record GPS.
2. 2. Photograph deposited sediment / affected area.
3. 3. Measure deposition depth at representative points.
4. 4. If a sediment contaminant screen is in scope, run the metals field kit and record values.
5. 5. Note debris, hazards, and the extent (sketch).
6. 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign.

If it does not match the plan

• Unstable ground / submerged debris / contaminated water -> document from safe footing; do not enter.
• Elevated metals in deposited sediment -> flag before any reuse; recommend lab confirm.

What counts as done

• Deposition depth recorded at representative points
• Metals screen recorded (if in scope)
• Debris/hazard note + extent sketch
• GPS waypoint + timestamped photos

Proof is measured against these, not judged by taste.