intermediate work · Invited home near Milpas St, Santa Barbara, CA 93103
Refresh peeling exterior trim on an invited Eastside Santa Barbara home
Santa Barbara's Eastside neighborhood along the Milpas Street corridor holds much of the city's working-class Latino community, in older homes whose exterior trim has gone years without attention while the westside's homes get regular upkeep. A trim paint refresh protects the wood underneath from the coastal air. Standard: Residential envelope exterior-maintenance practice โ SDG 11. Proof: Before/after photos of the refreshed trim Method (Residential envelope exterior-maintenance practice โ SDG 11.): 1. Photograph the peeling trim before starting. 2. Scrape loose, peeling paint from the trim. 3. Sand the surface smooth. 4. Prime and repaint the trim with matched exterior paint. 5. Photograph the finished trim with GPS and date. Done when: Before/after photos of the refreshed trim
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 45โ150 minutes. Method of record: Exterior building-envelope maintenance for existing housing -- gutter/downspout service, exterior debris removal, small envelope patch-and-seal, and foundation-grade moisture-source control. DOE Weatherization Assistance Program DIY-safe practice (envelope-adjacent) + EPA Healthy Homes moisture-control guidance; homeowner/occupant-safe hand-tool work only.
Bring
- camera
- gutter scoop or garden-hose gutter wand + bucket/tarp
- stepladder (6 ft max) + a spotter
- caulk gun + paintable/exterior sealant + patching compound
- rake, tarp, and yard-waste bags
- tape measure + line level or 4-ft level
- gloves + safety glasses
Steps
- 1. Photograph the gutter run, downspouts, exterior debris, and any envelope gaps or grading problem as found, from the vantage points that will be used again after.
- 2. Confirm scope with the occupant/owner and confirm the home's condition (post-1978, or pre-1978 with intact/unpainted-substrate work only -- any disturbed pre-1978 paint STOPS this scope and routes to an EPA RRP lead-safe pro).
- 3. From a stepladder no taller than 6 ft with a spotter (or from the ground for single-story eaves reachable by wand/scoop), clear debris from gutters and confirm downspouts drain freely and discharge at least several feet from the foundation; re-secure any loose gutter hangers.
- 4. Clear accumulated exterior debris/junk from the immediate building perimeter, porch, and walkway so drainage paths and pest-entry points stay clear; bag/stage yard waste for pickup.
- 5. Patch and seal small envelope gaps at trim, soffit, and utility penetrations with exterior-rated caulk or patching compound, and regrade a short run of soil away from the foundation where it currently slopes toward it.
- 6. Verify: gutters run clear water end-to-end, downspouts discharge away from the foundation, patched gaps are weathertight, and the perimeter is clear; photograph the finished work from the same vantage as the before photos.
- 7. Enter before/after photos, materials used, and any hazard flagged (active leak, structural rot, suspected lead paint) into the proof record; sign.
If it does not match the plan
- Pre-1978 home with peeling/chipping/disturbed paint on the work surface -> STOP: do not scrape or sand; route to an EPA RRP lead-safe certified pro.
- Active roof or plumbing leak, sagging gutter run, or structural rot found -> document and route to a licensed contractor; this scope is maintenance and prevention, not structural repair.
- Any ladder work above 6 ft, or an eave/gutter only reachable from the roof -> STOP this entry/intermediate scope; route to a credentialed crew.
What counts as done
- Before and after photos of gutters, downspouts, envelope gaps, and the cleared perimeter from matching vantage points
- Downspouts confirmed discharging away from the foundation (not pooling at the wall)
- Patched/sealed gaps are weathertight with no exposed raw gap remaining
- Perimeter debris cleared and staged/bagged for removal
Proof is measured against these, not judged by taste.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.