Patch a cracked curb ramp on an Eastside Santa Barbara sidewalk

Some sidewalks along the Milpas Street corridor have curb ramps cracked enough to catch a wheelchair wheel or a stroller, on a route families use daily to reach the bus line. A small patch repair keeps the crossing safe underfoot. Standard: ADA curb-ramp maintenance practice — SDG 11. Proof: Before/after photos of the patched curb ramp Method (ADA curb-ramp maintenance practice — SDG 11.): 1. Photograph the cracked or uneven ramp surface. 2. Clean debris from the crack. 3. Apply patch material and level the surface. 4. Let the patch cure per product instructions. 5. Photograph the finished, level ramp with GPS and date. Done when: Before/after photos of the patched curb ramp

Where

Public sidewalk near Milpas St, Santa Barbara, CA 93103

Pay

$220 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos of the patched curb ramp

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-03

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 240–600 minutes. Method of record: Curb ramp repair/retrofit to ADA + PROWAG R304 (slope, landing, detectable warning surface), under municipal right-of-way permit — trained crew with wet-cut dust controls; assess→repair→verify

Bring

• right-of-way permit + cones/barricades + pedestrian detour signage
• smart level / digital inclinometer + tape measure
• concrete tools + detectable warning surface (truncated dome) panel per city standard
• wet-cut saw with water feed (dust control)

Steps

1. 1. ASSESS: measure the existing ramp against PROWAG R304 (running slope ≤8.3%, cross-slope ≤2%, landing, flush transition, detectable warning) and photograph each failure; confirm permit + utility locates before cutting.
2. 2. Set up cones/barricades and a safe pedestrian detour outside the work zone.
3. 3. Remove the failed ramp section with wet-cut dust controls; form and place the corrected ramp geometry per the city standard drawing.
4. 4. Set the detectable warning surface (truncated domes) aligned and embedded per spec; finish transitions flush with the gutter.
5. 5. VERIFY: re-measure every R304 dimension with the smart level, photograph readings + before/after from matching vantage, water-test the gutter flow line, and close out the permit.

If it does not match the plan

• No permit or no utility locate -> STOP: do not cut.
• Cutting without water-fed dust control -> STOP (respirable silica).
• Geometry cannot meet R304 within the existing footprint -> document and route to the city's ADA transition-plan engineer instead of pouring a non-compliant ramp.

What counts as done

• Measured running slope ≤8.3% and cross-slope ≤2% with level photos
• Detectable warning surface installed per standard (alignment + embed photos)
• Flush gutter transition verified (no lip >1/4 inch; water flows along the gutter line)
• Before/after photos + permit close-out reference

Proof is measured against these, not judged by taste.