Swap the evaporative cooler pads before Atwater's hottest months (2026-07-19)

Many Atwater homes cool with evaporative coolers rather than AC, and worn-out pads mean the unit runs constantly without actually cooling the house. Standard: Manufacturer evaporative-cooler maintenance guidance + SDG 7 Affordable and Clean Energy Proof: Before/after photos of the cooler pads with unit confirmed running Method (Manufacturer evaporative-cooler maintenance guidance + SDG 7 Affordable and Clean Energy): 1. Confirm the household invited this visit and the cooler unit is powered off. 2. Open the cooler cabinet and remove the old pads. 3. Photograph the old pads' condition. 4. Install new pads sized to the unit, following the manufacturer's layout. 5. Restore power and run the unit briefly to confirm even water distribution. 6. Photograph the finished install with date. Done when: Before/after photos of the cooler pads with unit confirmed running

Where

Invited home, Atwater, CA 95301

Pay

$272 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Before/after photos of the cooler pads with unit confirmed running

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-08-19

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: ASHRAE Level 1 energy audit

Bring

• tablet/clipboard
• tape measure
• light meter (lighting scope)
• clamp thermometer (refrigeration scope)
• 12-month utility bills
• camera
• ladder + spotter (high fixtures)

Steps

1. 1. Confirm the address; arrange a staff escort for mechanical/back-of-house.
2. 2. Photograph HVAC, lighting, envelope, and any in-scope systems.
3. 3. Inventory systems: HVAC type + age; lighting fixture count/type/wattage; refrigeration units; envelope condition.
4. 4. Summarize 12 months of utility use (kWh / therms) from the bills.
5. 5. Take the in-scope measurements (light levels, unit temperatures, seal condition).
6. 6. Rank no-cost/low-cost measures, then capital measures, with rough savings logic.
7. 7. Enter inventory, measurements, utility summary, photos, and the ranked measure list; sign.

If it does not match the plan

• Knob-and-tube, ungrounded or overheated wiring, scorched outlets, or a hot electrical panel -> STOP: do not operate the circuit; route to a licensed electrician and restrict use (NEC / fire hazard).
• Gas odor, or a combustion appliance with absent/blocked venting (backdrafting / CO risk) -> STOP: evacuate, ventilate, call the gas utility. The agent escalates, never relights or adjusts gas.
• Any live-electrical/gas hazard -> document, do not touch, flag for a licensed pro.
• Refrigeration unit out of food-safe range -> flag as both energy and food-safety risk.
• Suspected asbestos/lead in materials -> flag and stop.

What counts as done

• System inventory complete for the in-scope equipment
• 12-month utility use summary recorded
• In-scope measurements recorded with units
• Ranked no-cost/low-cost + capital measure list produced

Proof is measured against these, not judged by taste.