Insulate the attic of a home on Jefferson Street to cut its energy loss (2026-07-20)

The attic above a home on Jefferson Street has insulation packed down to almost nothing after decades of settling, so heated and cooled air pours straight through the ceiling. A fresh, even layer closes that loss. Standard: DOE Weatherization Assistance Program, attic insulation measure Proof: Photo of the finished attic with depth measurement logged Method (DOE Weatherization Assistance Program, attic insulation measure): 1. Measure the attic floor area and current insulation depth 2. Clear the attic floor of stored debris blocking access 3. Lay baffles at the eaves to keep soffit vents clear 4. Install new insulation to the target depth across the floor 5. Photograph the finished attic floor and log the new depth Done when: Photo of the finished attic with depth measurement logged

Where

Jefferson St, Nashville, TN

Pay

$500 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Photo of the finished attic with depth measurement logged

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-08-19

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–120 minutes. Method of record: ASHRAE Level 1 energy audit

Bring

• tablet/clipboard
• tape measure
• light meter (lighting scope)
• clamp thermometer (refrigeration scope)
• 12-month utility bills
• camera
• ladder + spotter (high fixtures)

Steps

1. 1. Confirm the address; arrange a staff escort for mechanical/back-of-house.
2. 2. Photograph HVAC, lighting, envelope, and any in-scope systems.
3. 3. Inventory systems: HVAC type + age; lighting fixture count/type/wattage; refrigeration units; envelope condition.
4. 4. Summarize 12 months of utility use (kWh / therms) from the bills.
5. 5. Take the in-scope measurements (light levels, unit temperatures, seal condition).
6. 6. Rank no-cost/low-cost measures, then capital measures, with rough savings logic.
7. 7. Enter inventory, measurements, utility summary, photos, and the ranked measure list; sign.

If it does not match the plan

• Knob-and-tube, ungrounded or overheated wiring, scorched outlets, or a hot electrical panel -> STOP: do not operate the circuit; route to a licensed electrician and restrict use (NEC / fire hazard).
• Gas odor, or a combustion appliance with absent/blocked venting (backdrafting / CO risk) -> STOP: evacuate, ventilate, call the gas utility. The agent escalates, never relights or adjusts gas.
• Any live-electrical/gas hazard -> document, do not touch, flag for a licensed pro.
• Refrigeration unit out of food-safe range -> flag as both energy and food-safety risk.
• Suspected asbestos/lead in materials -> flag and stop.

What counts as done

• System inventory complete for the in-scope equipment
• 12-month utility use summary recorded
• In-scope measurements recorded with units
• Ranked no-cost/low-cost + capital measure list produced

Proof is measured against these, not judged by taste.