Restore the street tree pits in front of Brown Chapel AME Church, with the congregation's welcome (2026-07-20)

The tree pits along the sidewalk in front of Brown Chapel AME Church sit bare after past trees died, leaving the entrance to this historic landmark without shade for visitors who walk in from the street. With the church's welcome, restoring the pits and planting again brings that shade back. Standard: SDG 11 Sustainable Cities, urban tree canopy restoration Proof: Photo of each restored pit with species and GPS tag logged Method (SDG 11 Sustainable Cities, urban tree canopy restoration): 1. Confirm the planting scope with the church caretaker 2. Clear trash and debris from each empty tree pit 3. Loosen and amend the compacted soil in the pit 4. Set a new young tree at the correct planting depth, backfill, water, and mulch 5. Photograph each restored pit and log the species planted Done when: Photo of each restored pit with species and GPS tag logged

Where

410 Martin Luther King Jr St, Selma, AL

Pay

$220 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Photo of each restored pit with species and GPS tag logged

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-08-19

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: Street-tree pit restoration per ISA arboriculture BMPs + municipal urban-forestry standards (de-compact, weed, amend, mulch, water) — hand tools only, no root cutting; assess→restore→verify

Bring

• hand cultivator/garden fork + weeding tools (hand tools only)
• arborist wood-chip mulch (3-inch layer, keep off the trunk flare)
• watering container(s) / water source access
• camera + measuring tape

Steps

1. 1. ASSESS: photograph the tree pit as found; note compaction, weeds, trash, girdling material (wire, cords, mats), soil level against the trunk flare, and visible trunk damage.
2. 2. Clear trash and weeds by hand; remove any girdling material from the trunk wherever it lifts free without cutting bark.
3. 3. De-compact the top 2–3 inches of pit soil with a hand fork WITHOUT cutting roots ≥1 inch — work around them; level soil away from the trunk flare so the flare is visible.
4. 4. Apply a 3-inch arborist-chip mulch ring keeping a 3-inch gap at the trunk (no volcano mulching), and water thoroughly (15–20 gallons for a young tree).
5. 5. VERIFY: photograph the finished pit from the matching vantage (flare visible, mulch ring correct, pit weed-free) and log the watering; flag dead/hazard limbs or trunk wounds to the municipal urban-forestry line — never prune above shoulder height yourself.

If it does not match the plan

• Roots ≥1 inch in the work zone -> work around them; never cut structural roots.
• Dead/hanging limbs, major trunk wounds, or a leaning tree -> photograph and report to urban forestry; no pruning above shoulder height, no ladder work.
• Suspected utility conflict in the pit (exposed line, meter box) -> stop digging and report.

What counts as done

• Before/after photos from matching vantage; trunk flare visible, no mulch against bark
• Pit de-compacted and weed/trash-free; girdling material removed and photographed
• Watering completed and logged (volume noted)

Proof is measured against these, not judged by taste.