Restore a street tree pit at a public right-of-way in San Ardo, CA (2026-07-24)

The street tree pits along the public right-of-way in San Ardo, CA are compacted, weed-choked, and littered, slowly stressing the shade canopy. Restoring a pit gives the tree room to thrive. Standard: SDG 11.7 green public space + i-Tree canopy assessment protocol Proof: before/after photos + compaction check + mulch-ring confirm + GPS Method (i-Tree canopy / street-tree inventory, ~30-60 min): 1. Walk the corridor; record a GPS waypoint at each tree. 2. Photograph each surveyed tree. 3. Record species (best estimate), condition class (good/fair/poor/dead), and DBH (diameter at breast height). 4. Count vacant planting sites. 5. Enter the per-tree records, vacant-site count, GPS, photos into the proof record; sign. Equipment: GPS phone, DBH tape or measuring tape, tree ID reference, camera, hi-vis vest Done when: Per-tree species + condition + DBH recorded; Vacant planting sites counted; GPS waypoint per tree; Photo per surveyed tree

Where

a public right-of-way in San Ardo, CA

Pay

$120 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

before/after photos + compaction check + mulch-ring confirm + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-08-23

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: Street-tree pit restoration per ISA arboriculture BMPs + municipal urban-forestry standards (de-compact, weed, amend, mulch, water) — hand tools only, no root cutting; assess→restore→verify

Bring

• hand cultivator/garden fork + weeding tools (hand tools only)
• arborist wood-chip mulch (3-inch layer, keep off the trunk flare)
• watering container(s) / water source access
• camera + measuring tape

Steps

1. 1. ASSESS: photograph the tree pit as found; note compaction, weeds, trash, girdling material (wire, cords, mats), soil level against the trunk flare, and visible trunk damage.
2. 2. Clear trash and weeds by hand; remove any girdling material from the trunk wherever it lifts free without cutting bark.
3. 3. De-compact the top 2–3 inches of pit soil with a hand fork WITHOUT cutting roots ≥1 inch — work around them; level soil away from the trunk flare so the flare is visible.
4. 4. Apply a 3-inch arborist-chip mulch ring keeping a 3-inch gap at the trunk (no volcano mulching), and water thoroughly (15–20 gallons for a young tree).
5. 5. VERIFY: photograph the finished pit from the matching vantage (flare visible, mulch ring correct, pit weed-free) and log the watering; flag dead/hazard limbs or trunk wounds to the municipal urban-forestry line — never prune above shoulder height yourself.

If it does not match the plan

• Roots ≥1 inch in the work zone -> work around them; never cut structural roots.
• Dead/hanging limbs, major trunk wounds, or a leaning tree -> photograph and report to urban forestry; no pruning above shoulder height, no ladder work.
• Suspected utility conflict in the pit (exposed line, meter box) -> stop digging and report.

What counts as done

• Before/after photos from matching vantage; trunk flare visible, no mulch against bark
• Pit de-compacted and weed/trash-free; girdling material removed and photographed
• Watering completed and logged (volume noted)

Proof is measured against these, not judged by taste.