Hand-clear surface debris from the desert-wash edge, site 1 -- US-395 desert-wash crossing, north Adelanto, CA 92301 (2026-07-24)

Wind-blown trash and tumbleweed pile up along this Mojave desert-wash edge near US-395, and every piece left there is one flash flood away from damming the channel and pushing storm water into the road instead of through it. Standard: FEMA floodplain + green-infrastructure siting screen; SDG 11.5 disaster resilience. Proof: before/after photos + debris-volume log + dry-conditions confirm + GPS Method (FEMA floodplain + green-infrastructure siting screen; SDG 11.5 disaster resilience.): 1. 1. Walk the dry wash edge under normal (non-storm) conditions and photograph the debris as found, staying on the accessible bank. 2. 2. Hand-clear surface trash and debris (bottles, bags, wind-blown litter, tumbleweed piles) from the wash edge, bagging it for haul-off. 3. 3. Never enter the wash channel itself or work during/after rain -- surface-edge clearing only, in dry conditions. 4. 4. Photograph the cleared wash edge from the matching before vantage and log the debris volume removed. Done when: before/after photos + debris-volume log + dry-conditions confirm + GPS

Where

US-395 desert-wash crossing, north Adelanto, CA 92301

Pay

$95 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

before/after photos + debris-volume log + dry-conditions confirm + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-10-23

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: FEMA floodplain + green-infrastructure siting screen

Bring

• GPS phone
• tape/ruler for deposition depth
• metals field kit (if sediment screen in scope)
• boots + gloves
• camera

Steps

1. 1. Confirm post-event conditions are safe; navigate to the site; record GPS.
2. 2. Photograph deposited sediment / affected area.
3. 3. Measure deposition depth at representative points.
4. 4. If a sediment contaminant screen is in scope, run the metals field kit and record values.
5. 5. Note debris, hazards, and the extent (sketch).
6. 6. Enter depth, any analytes, hazard notes, GPS, photos into the proof record; sign.

If it does not match the plan

• Unstable ground / submerged debris / contaminated water -> document from safe footing; do not enter.
• Elevated metals in deposited sediment -> flag before any reuse; recommend lab confirm.

What counts as done

• Deposition depth recorded at representative points
• Metals screen recorded (if in scope)
• Debris/hazard note + extent sketch
• GPS waypoint + timestamped photos

Proof is measured against these, not judged by taste.