Clean out the waterbars and rolling dips on an invited access road mid-corridor, Feather Falls

Every home up here hangs off a dirt access road, and a silted waterbar sends winter runoff straight down the grade -- washboard by December, gully by March, sediment in the creek all along. Shovel-and-McLeod cleanout of the bars and dips before the rain is the known annual job of hill living. Standard: Rolling-dip and waterbar cleanout on private residential access roads per USFS/RCD low-volume-roads maintenance practice -- shovel-and-McLeod surface work that keeps winter runoff off the road grade and out of the creek. SDG 11.5 / SDG 15. Proof: before/after photos per bar/dip + GPS + count note Method (Storm drain inlet surface cleaning + minor grate/apron repair per EPA MS4 stormwater BMP maintenance — SURFACE WORK FROM THE CURB ONLY; never enter the drain, never lift beyond the grate; assess→clear/repair→verify, ~60-180 min): 1. ASSESS: photograph the inlet as found (grate, apron, gutter approach), note blockage type and any damage (broken grate, displaced apron concrete), and record GPS. 2. Set cones at the curb work zone; all work is from the sidewalk/curb — never step into the traffic lane and never enter, reach into, or open the drain structure. 3. Clear debris, sediment, and litter from the grate surface and the gutter approach with the rake/grabber; bag and dispose of it properly (green waste separated). 4. Minor repair within surface scope: re-seat a displaced grate that lifts freely by hand from above, patch apron spalls with cold-patch where the city standard allows; anything more is documented, not attempted. 5. VERIFY: photograph the cleared inlet from the same vantage, pour a bucket of clean water at the gutter approach to show flow into the inlet, and report any structural damage to the municipal stormwater line (311/MS4 contact) with photos. Equipment: heavy work gloves + hi-vis vest + grabber tool and rake, contractor bags for debris (landscape debris separated from trash), camera + measuring tape, cones for the curb work zone (stay out of the traffic lane) Done when: Before/after photos from matching vantage show the grate and gutter approach clear; Water-flow photo/video shows drainage into the inlet with no ponding at the approach; Debris bagged and disposed (photo), green waste separated; Any structural damage reported to the municipal stormwater contact with the report reference recorded

Where

the Lumpkin Road residential corridor, Feather Falls, Butte County, CA

Pay

$280 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

before/after photos per bar/dip + GPS + count note

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-10

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 60–180 minutes. Method of record: Storm drain inlet surface cleaning + minor grate/apron repair per EPA MS4 stormwater BMP maintenance — SURFACE WORK FROM THE CURB ONLY; never enter the drain, never lift beyond the grate; assess→clear/repair→verify

Bring

• heavy work gloves + hi-vis vest + grabber tool and rake
• contractor bags for debris (landscape debris separated from trash)
• camera + measuring tape
• cones for the curb work zone (stay out of the traffic lane)

Steps

1. 1. ASSESS: photograph the inlet as found (grate, apron, gutter approach), note blockage type and any damage (broken grate, displaced apron concrete), and record GPS.
2. 2. Set cones at the curb work zone; all work is from the sidewalk/curb — never step into the traffic lane and never enter, reach into, or open the drain structure.
3. 3. Clear debris, sediment, and litter from the grate surface and the gutter approach with the rake/grabber; bag and dispose of it properly (green waste separated).
4. 4. Minor repair within surface scope: re-seat a displaced grate that lifts freely by hand from above, patch apron spalls with cold-patch where the city standard allows; anything more is documented, not attempted.
5. 5. VERIFY: photograph the cleared inlet from the same vantage, pour a bucket of clean water at the gutter approach to show flow into the inlet, and report any structural damage to the municipal stormwater line (311/MS4 contact) with photos.

If it does not match the plan

• Anything requiring entry, reaching into the barrel, or lifting a seized grate -> STOP: document and report to the municipality; surface work only.
• Suspected illicit discharge (odor, sheen, off-color flow) -> do not touch; photograph from the curb and report to the MS4 hotline immediately.
• Inlet on a high-speed road with no safe curb work zone -> document from the sidewalk only and report; never work in the traffic lane.

What counts as done

• Before/after photos from matching vantage show the grate and gutter approach clear
• Water-flow photo/video shows drainage into the inlet with no ponding at the approach
• Debris bagged and disposed (photo), green waste separated
• Any structural damage reported to the municipal stormwater contact with the report reference recorded

Proof is measured against these, not judged by taste.