Document a bare, sloughing redbed and gypsum canyon slope at Caprock Canyons, segment 2, Caprock Canyons State Park, established park road pullout below a redbed and gypsum canyon slope, Quitaque, Briscoe County, TX 79255 (2026-07-29)

This redbed and gypsum canyon slope inside Caprock Canyons State Park is actively sloughing loose material onto the park road below with no photo record to prioritize it for stabilization. Standard: USDA NRCS Soil Health assessment practice (gully condition, slope stability, wind and water erosion) plus SDG 15.3 land degradation neutrality, applied here to the escarpment gully heads and redbed and gypsum canyon slopes of Caprock Canyons State Park near Quitaque, Briscoe County, Texas, the landform where the Llano Estacado High Plains drops into the Panhandle's canyon breaks. Proof: document-only stand-off photo log plus slope-face dimension estimate plus GPS plus ranked follow-on note Method (USDA NRCS Soil Health assessment practice (gully condition, slope stability, wind and water erosion) plus SDG 15.3 land degradation neutrality, applied here to the escarpment gully heads and redbed and gypsum canyon slopes of Caprock Canyons State Park near Quitaque, Briscoe County, Texas, the landform where the Llano Estacado High Plains drops into the Panhandle's canyon breaks.): 1. 1. From an established park road pullout or trail, photograph a bare, actively sloughing redbed or gypsum canyon slope, without stepping onto the loose slope face. 2. 2. Note the approximate width and height of the bare, eroding slope face. 3. 3. Photograph the nearest park road mile marker or trail marker for the crew's reference. 4. 4. Record a ranked follow on note naming the segment for the redbed gypsum slope stabilization install crew. Done when: document-only stand-off photo log plus slope-face dimension estimate plus GPS plus ranked follow-on note

Where

Caprock Canyons State Park, established park road pullout below a redbed and gypsum canyon slope, Quitaque, Briscoe County, TX 79255

Pay

$90 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

document-only stand-off photo log plus slope-face dimension estimate plus GPS plus ranked follow-on note

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-08-28

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: USDA-NRCS soil-health in-situ assessment

Bring

• soil auger or trowel
• infiltration ring + measured water + timer
• penetrometer (if compaction in scope)
• clean bucket
• sample bags + labels
• gloves
• GPS phone
• camera

Steps

1. 1. Navigate to the plot; record GPS; sketch the sampling layout.
2. 2. Photograph each sampling station.
3. 3. Run the infiltration ring; record time to infiltrate 1 inch.
4. 4. Assess aggregate stability and note visible organic matter, roots, and biology.
5. 5. If compaction is in scope, record penetrometer resistance by depth.
6. 6. Collect 0-15 cm cores if a lab subsample is specified; bag, label, complete COC.
7. 7. Enter all measurements with units + depth, GPS, photos into the proof record; sign.

If it does not match the plan

• Infiltration > 30 min/inch or high penetrometer resistance -> flag compaction; recommend cover crop / reduced traffic.
• Very low organic matter / no visible biology -> flag degraded; recommend amendment plan.

What counts as done

• Infiltration time recorded
• Aggregate stability + organic-matter observation recorded
• Each in-scope measurement recorded with units and depth
• GPS waypoint + station photos + site sketch

Proof is measured against these, not judged by taste.