Set up a public water refill point at a public right-of-way in Jackson, MS

People in Jackson, MS have no free, shaded spot to refill water on hot days. A public refill point gives one. Standard: NSF/ANSI 53/42 certified filtration at point of dispensing; SDG 6.1 and 12.5. Proof: Running-station photo with certification and log card Method (NSF/ANSI 53/42 certified filtration at point of dispensing; SDG 6.1 and 12.5.): 1. Confirm placement and plumbing access with the site host. 2. Mount the refill unit or filtered dispenser and connect it through an NSF-certified filter per the manufacturer's instructions. 3. Flush the system, check all fittings for leaks, and verify flow and clarity. 4. Post the filter's rating, cartridge-change log card, and simple use instructions at the station. 5. Photograph the finished station running, the certification mark, and the posted log with GPS and date. Done when: Photos of the installed station dispensing, GPS and date; Certification mark photo; Posted cartridge log card photo

Where

a public right-of-way in Jackson, MS

Pay

$380 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

Running-station photo with certification and log card

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-14

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 30–60 minutes. Method of record: EPA drinking-water sampling (3Ts / LCR first-draw where lead is in scope)

Bring

• GPS-capable phone
• test kit for each named analyte (nitrate/coliform/arsenic/lead as specified)
• clean sample bottle + label
• nitrile gloves
• camera

Steps

1. 1. Navigate to the sampling point; confirm GPS is inside the posting radius; record the waypoint.
2. 2. Photograph the tap or wellhead with a legible timestamp.
3. 3. If first-draw is required, sample after >=6h stagnation; if flushed, run the tap 2-3 minutes first, then sample.
4. 4. Fill the bottle without touching the inside; cap immediately.
5. 5. Run each test per kit instructions; wait the exact develop/incubation time; read and record every value with units.
6. 6. Record coliform as present/absent after the stated incubation window.
7. 7. Enter all readings, units, GPS, time, and photos into the proof record; sign it.

If it does not match the plan

• Nitrate > 10 mg/L -> tag 'exceeds EPA MCL'; advise no infant consumption pending certified-lab confirmation.
• Total coliform present -> advise disinfection + retest; recommend lab confirmation.
• Arsenic > 10 ppb or Lead > 15 ppb -> tag exceedance; recommend certified-lab confirmation before any consumption guidance.

What counts as done

• GPS waypoint recorded inside the posting radius
• Timestamped photo of the exact sampling point
• Each required analyte recorded with a numeric value + units (or present/absent)
• Sampling type (first-draw vs flushed) explicitly noted

Proof is measured against these, not judged by taste.