Anyone can start here · Invited oasis garden, Marrakech, Morocco
Run the weekly watering round for young trees in a Marrakech oasis garden (2026-08-03)
Run the weekly watering round for young trees in a Marrakech oasis garden…. Fund it for $140. Proof lands on-chain when it's done.
Marrakech's oasis-garden tradition depends on young trees surviving their first two dry seasons, and a consistent weekly watering round is what makes the difference in desert heat. Standard: FAO tree establishment and aftercare guidance: SDG 13 (Climate Action) & SDG 15 (Life on Land). Proof: Photo of each tree watered, with GPS pin. Method (FAO tree establishment and aftercare guidance: SDG 13 (Climate Action) & SDG 15 (Life on Land).): 1. Identify the young trees on your assigned garden section. 2. Check soil moisture at the base of each tree. 3. Water each tree thoroughly at the base. 4. Clear any litter from the tree basin. 5. Photograph each watered tree. Done when: Photo of each tree with GPS pin and timestamp; Note on soil moisture before watering; Count of trees watered this round
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: ANSI A300 Part 6 (Planting) + ISA Best Management Practices for tree planting & establishment; Arbor Day Foundation planting standard. DIY-safe volunteer planting on cleared, utility-marked ground; no mechanized or utility-conflict digging.
Bring
- GPS-capable phone
- camera
- round-point shovel + digging fork
- hand pruners
- mulch (wood chips) + measuring stick
- watering can or hose
- gloves + closed-toe boots
Steps
- 1. Confirm the planting spot is inside the posting radius and clear of marked utilities (811 locate honored); record the GPS waypoint.
- 2. Photograph the bare site and the nursery stock (label/species visible) before planting.
- 3. Dig the hole 2-3x the root-ball width and no deeper than the root ball, so the root flare will sit at or just above grade.
- 4. Remove the container or cut away burlap/wire, gently loosen circling roots, and set the tree with the root flare visible at grade.
- 5. Backfill with the native soil in layers, firming out air pockets; do not bury the root flare or amend heavily.
- 6. Build a shallow watering basin, water in slowly until the backfill is saturated, and apply 2-3 inches of mulch kept 3 inches off the trunk.
- 7. Stake only if the tree cannot stand on its own; use two loose ties that allow trunk movement, and note a removal date within one year.
- 8. Record species, GPS, before/after photos, root-flare-at-grade confirmation, mulch depth, and water applied into the proof record; sign.
If it does not match the plan
- Unmarked or suspected buried utility, or the 811 locate is not honored -> STOP: do not dig; reschedule after a confirmed locate.
- Root ball is dry, circling/kinked, or the trunk is wounded -> do not plant as-is; soak/correct or reject the stock and note it, rather than establish a failing tree.
- Right-of-way, overhead-line conflict, or a species/site mismatch -> flag for the site steward and choose an approved spot/species; never plant into a conflict.
What counts as done
- Photo of each tree with GPS pin and timestamp
- Note on soil moisture before watering
- Count of trees watered this round
Proof is measured against these, not judged by taste.
The standard this serves
Tree Planting and Establishment. Planting a tree properly is a codified craft, and the arborists' standards are blunt about why: most young trees that die were killed at planting, by a hole dug too deep, a root ball left bound, a first summer without water. Mastery looks like trees you planted years ago still standing, which is the only measure arborists accept. The craft lives in exactly the steps this packet asks for: the wide shallow hole, the freed roots, the mulch kept off the trunk, the watering that follows. Plant one tree correctly and you know something real.
Funding this work is a purchase or a vote, same act: you either want this done here, or you want the world to contain it. Either way the money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1785717209027_y8jjy4m","funderWallet":"0xYOU"}.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.