Anyone can start here · Ramey Avenue tree line, Stop Six, Fort Worth, TX
Water the New Street Trees Along Ramey Avenue, Stop Six, Fort Worth (2026-08-03)
Water the New Street Trees Along Ramey Avenue, Stop Six, Fort Worth (2026-08-03). Fund it for $150. Proof lands on-chain when it's done.
Young street trees planted along Ramey Avenue need regular watering through their first two Texas summers, or the block loses the shade investment before the canopy establishes. Standard: USDA Forest Service Urban and Community Forestry program; LBC Place petal Proof: Photos show the tree pit or planting complete, GPS tagged to the exact tree. Method (USDA Forest Service Urban and Community Forestry program; LBC Place petal): 1. Locate each young tree using the planting log. 2. Check the soil moisture at the root zone before watering. 3. Slow-water each tree at the base. 4. Check the stake and mulch ring for each tree. 5. Photograph each tree and log the watering round. Done when: before-and-after photos of the tree pit or planting; GPS tag of the tree; written log of species and care performed
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 90–240 minutes. Method of record: Urban heat-island mitigation for civic hard surfaces and pedestrian waiting areas, high-solar-reflectance (cool) coatings on sidewalks/schoolyards/plazas and shade-sail/structure installs at bus stops and gathering points. EPA Heat Island Reduction Program cool-pavement guidance + ASTM E1918 solar-reflectance testing; municipal right-of-way permit where the surface or structure sits in the public way.
Bring
- camera + infrared/surface thermometer
- push broom + pressure washer (surface prep)
- roller/squeegee applicators for cool-pavement coating (manufacturer-specified system only)
- cones/barricades for the work-zone perimeter
- post-hole digger or core drill + concrete anchors (shade-structure footings)
- tape measure + level
- gloves + safety glasses + respirator as coating manufacturer specifies
Steps
- 1. Photograph the target surface or waiting area as found, including a mid-day surface-temperature reading, and confirm the right-of-way permit and any utility locates before ground disturbance.
- 2. Set cones/barricades for a pedestrian-safe work zone; pressure-wash and clear the surface of debris, or confirm the shade-structure footing location clears underground utilities (811 locate) and meets the manufacturer's anchor spec.
- 3. Apply the cool-pavement coating system per manufacturer instructions in the specified number of coats and cure time, OR set and anchor the shade structure/sail per its engineering spec, keeping clearances for accessible passage.
- 4. Verify: for coatings, confirm even coverage with no missed sections and let the full cure window pass before reopening to traffic; for structures, confirm anchor torque and structural stability by hand-test.
- 5. Take a matching-vantage after photo and a same-conditions surface-temperature reading; log the reading delta.
- 6. Enter before/after photos, the temperature readings, materials/product used, and the permit reference into the proof record; sign.
If it does not match the plan
- No right-of-way permit on file for public-way work -> STOP: do not apply coating or set a structure until the permit is confirmed.
- 811 utility locate not confirmed before any ground disturbance for a footing -> STOP: reschedule after locates are marked.
- Coating manufacturer's minimum surface-prep or cure-time spec cannot be met (rain in the cure window, surface too degraded) -> reschedule rather than apply out of spec.
What counts as done
- before-and-after photos of the tree pit or planting
- GPS tag of the tree
- written log of species and care performed
Proof is measured against these, not judged by taste.
Funding this work is a purchase or a vote, same act: you either want this done here, or you want the world to contain it. Either way the money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1785717677859_rpwv1jo","funderWallet":"0xYOU"}.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.