intermediate work · the public Palo Duro Canyon State Park, a canyon-rim overlook trail segment near Canyon, TX 79015, Randall County
Seed native mixed grass cover on a Palo Duro canyon rim segment, site 2, the public Palo Duro Canyon State Park, a canyon-rim overlook trail segment near Canyon, TX 79015, Randall County (2026-08-04)
Seed native mixed grass cover on a Palo Duro canyon rim segment, site 2, the public…. Fund it for $155. Proof lands on-chain when it's done.
The survey above found a bare or wind-scoured canyon-rim segment along the public overlook trail on Palo Duro Canyon State Park, and a hand seeded native mixed grass mix would otherwise leave this rim segment open to further wind erosion for another season. Standard: USDA NRCS conservation practice standard 550 range planting plus standard 643 restoration of rare or declining habitats (canyon-rim mixed-grass restoration), applied here to a public overlook trail segment inside Palo Duro Canyon State Park near Canyon, TX, Randall County. SDG 15.1 and 15.3. Proof: before after photos plus species and area seeded record plus GPS Method (USDA NRCS conservation practice standard 550 range planting plus standard 643 restoration of rare or declining habitats (canyon-rim mixed-grass restoration), applied here to a public overlook trail segment inside Palo Duro Canyon State Park near Canyon, TX, Randall County. SDG 15.1 and 15.3.): 1. 1. Confirm the segment with the state park office and photograph the bare or eroded rim segment before starting, staying set well back from the unprotected rim edge. 2. 2. Hand rake the surface only to loosen the top layer of soil, no power equipment, no digging below the surface. 3. 3. Hand broadcast a native mixed grass seed mix suited to the canyon rim (sideoats grama, little bluestem, blue grama). 4. 4. Hand mulch the seeded area with certified weed free straw and photograph the seeded segment from the matching before vantage, recording species and area seeded. Done when: Before photo of the bare or eroded rim segment; Confirmation only hand tools were used, surface only, no digging below the surface, work stayed set well back from the rim edge; Native species and area seeded recorded; After photo of the seeded segment from the matching vantage
How this work is done
A documented method, so this packet comes out the same whoever does it. Typically 45–120 minutes. Method of record: Point-count / transect species survey (Breeding Bird Survey + Xerces pollinator-count protocols)
Bring
- binoculars
- field ID guide or app
- GPS phone
- data sheet / recorder
- timer
- camera
Steps
- 1. Navigate to the first survey point; record GPS; note start time, weather, and wind (surveys pause in rain/high wind).
- 2. Wait a settling minute, then run a fixed-duration count (e.g., 5 min) within a fixed radius; record every species seen/heard and the count of each.
- 3. Photograph the habitat and any species you can; note any threatened/target or invasive species.
- 4. Move to the next point along the transect (keep points >=200 m apart) and repeat the count.
- 5. Record total effort (points, duration) and observer.
- 6. Enter the per-point species lists + counts, GPS, weather, effort, and photos into the proof record; sign.
If it does not match the plan
- Threatened/at-risk or target species observed -> flag for the land steward (with location) for protection planning.
- Invasive species dominant / native diversity very low -> flag for a management plan.
- Rain or high wind -> pause/reschedule; counts under poor conditions are not valid.
What counts as done
- Before photo of the bare or eroded rim segment
- Confirmation only hand tools were used, surface only, no digging below the surface, work stayed set well back from the rim edge
- Native species and area seeded recorded
- After photo of the seeded segment from the matching vantage
Proof is measured against these, not judged by taste.
Funding this work is a purchase or a vote, same act: you either want this done here, or you want the world to contain it. Either way the money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1785875736781_wkd2pil","funderWallet":"0xYOU"}.
Claiming is free. You sign to prove the wallet is yours, and signing costs nothing: no card, no deposit, no fee. An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.