ILO C167 pre-task site-safety walk: urban high-rise construction site (Mexico City)

A dense urban high-rise construction site in Mexico City relies on the crew's own checks with no third-party pre-task safety documentation; fall, scaffold, and temporary-electrical hazards go unrecorded against the ILO C167 / national OSH baseline.

Where

urban high-rise construction site, Mexico City, Mexico · Open the map

Pay

$220 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

photo per checklist section + GPS + ILO C167 / national-law checklist + tiered findings routed to the responsible person

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-09-05

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it. Typically 45–90 minutes. Method of record: ILO C167 Safety and Health in Construction (1988) + WHO healthy-workplace pre-task site-safety walk (national OSH law where stricter)

Bring

• site PPE (hard hat / eye protection / hi-vis per site)
• tablet/clipboard with the ILO C167 checklist
• camera
• tape measure
• note on the national OSH requirements + the responsible/competent person

Steps

1. 1. Check in with the site's responsible/competent person; confirm scope, don PPE, and confirm you observe-and-document only. Note the applicable national OSH law (ILO C167 is the floor).
2. 2. Walk fall exposure: photograph unprotected edges/openings, guardrails/covers, and any fall-arrest anchorage in use (ILO C167 Art. 24, work at height).
3. 3. Inspect scaffold and ladder condition: footing, ties, planking, guardrails; ladder pitch and tie-off (ILO C167 Art. 14-15).
4. 4. Screen temporary electrical: cord/panel condition, isolation, and protection against contact (ILO C167 Art. 21).
5. 5. Record housekeeping, access/egress, and PPE provision + use (ILO C167 Art. 28-30).
6. 6. Tier each finding against ILO C167 / national law (stop-work / correct-before-proceed / monitor) and name the responsible person.
7. 7. Enter photos, GPS/address, the checklist, and the tiered findings; sign. Route stop-work items to the responsible person with a timestamp.

If it does not match the plan

• Unprotected fall exposure at height with no guardrail/cover/anchorage in use -> STOP-WORK: document, clear the area, route to the responsible person; do not proceed past the exposure (ILO C167).
• Damaged/incomplete scaffold or a non-compliant ladder in active use -> STOP-WORK for that element; flag to the responsible person, do not use.
• Temporary electrical with exposed conductors or no isolation/protection -> flag as an electrocution hazard; do not touch; route to a qualified electrician.
• No PPE provided where the hazard requires it, or any confined-space/excavation/hot-work condition -> observe-and-document only; never enter; route to the responsible/competent person. Approval and correction stay human.

What counts as done

• Photos of fall-exposure, scaffold/ladder, temporary-electrical, and housekeeping/PPE conditions
• GPS / address confirm
• ILO C167 checklist with the applicable national OSH reference noted
• Tiered findings list (stop-work / correct-before-proceed / monitor) with the responsible person named
• Timestamp of stop-work items routed to the responsible person

Proof is measured against these, not judged by taste.