5600-5700 block of W Wilshire Blvd (commercial + food service), Los Angeles, CA 90036
Flow-test every tap and fix the one dripping faucet, 5600-5700 W Wilshire block.
Time every tap with a bucket and a stopwatch, then fit a new washer in the one that drips. Read all of it
Not funded yet. Settles as earned credit, $80 proposed.
Proof it takes, the deadline, the level
- Proofdated flow list (gpm per fixture) + before drip video or photo + after dry-spout photo + GPS
- Open until2026-11-10
- Levelentry
All of it: the words, the place, the proof
Time every tap with a bucket and a stopwatch, then fit a new washer in the one that drips. A commercial space never meets its own water: taps run at unknown rates and one faucet always drips. One afternoon makes the flow honest. For the payer: - Likely payer: The building's owner or manager, paying directly. - No license is needed while the whole job, labor and materials together, stays under $1,000 (Business and Professions Code section 7048); at $1,000 or more, a CSLB C-36 Plumbing license.
Offer to pay $80. The receipt lands onchain once the proof is approved.
Safety, read before you claim
Get the owner's or manager-on-duty's go-ahead before touching a fixture. Hand tools only; close the supply stop first, and if a stop will not close or the fixture feeds equipment, list it and do not open it.
The full safety list for this job:
- Gear, Title 8 sections 3385 and 3384: slip-resistant closed-toe shoes for wet floors and dropped fixtures; nitrile gloves for descaler, cleaners and sealant.
- Orientation, section 3203: the crew's injury and illness prevention program orientation comes before any work.
- Do not shut off supply to a working kitchen or restroom without the go-ahead. Equipment fed by a fixture (dish machine, ice, boiler) is listed, never opened.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Steps
- Obtain the owner's or manager's written consent for this work at this address before you start (a signed form, an email or a text that names the address and the work). Write who gave it and the date at the top of your proof. With no consent, stop.
- Bucket-and-stopwatch every tap in the space: time ten seconds of full flow, convert to gallons per minute, and write each fixture's rate on a dated list.
- Note every drip, run-on, or fixture that will not shut fully while you go.
- Pick the one dripping faucet, shut its supply stop, and replace the washer or cartridge with a matching hardware-store part.
- Re-open the supply, confirm the drip is gone, and photograph the dry spout next to the stopped stopwatch.
- Hand the building the flow list with rates, the drip log, and the one fixed fixture marked done.
What counts as done
- Dated flow list with a gallons-per-minute figure per fixture
- Photo or short video of the drip before the fix
- Photo of the dry spout after, with the replaced part's packaging
- GPS waypoint of the space
- Site record: the exact site's name and street address, and the contact who agreed to the work
- Consent: the owner's or manager's written consent, naming the address and the work, dated before the first photo.
- Sign-off: the owner or manager signs off the finished work in writing. Write who signed and the date, or the date you asked.
- Photos: take the before photo and the after photo from the same point (stand where the first one was taken and match its frame), each with its GPS point and its date and time.
Proof is measured against these, not judged by taste.
The standard this serves
Living Building Challenge, Water Petal. The Water Petal asks a building to live within its own rain: catch what falls on the roof, use it carefully, clean what leaves, waste nothing. Mastering it looks like a home where low-flow fixtures, a rain barrel, and a planted greywater bed quietly do work a city treatment plant once did. That whole begins small. One fixture swapped, one leak found and timed with a bucket, one gallon accounted for. This packet is that beginning. Water mastery is not equipment you buy; it is the habit of knowing where every drop goes.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.
Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1786407120668_lgj3zdl