Walk the safety checklist.

A mobile-crane lift in Omaha, NE needs an independent, documented pre-task safety walk against the standard checklist, never trade work, only observation, photos, and a tiered findings list routed to the site's competent person.

Where

Mobile-crane lift, Omaha, NE · Open the map

Pay

$528 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

photo from a safe distance per checklist section + GPS + Subpart CC checklist + tiered findings

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-08-18

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• hard hat + safety glasses + hi-vis vest (site PPE)
• tablet/clipboard with the OSHA Subpart CC pre-lift checklist
• camera with zoom (observe from a safe distance)
• tape measure / measuring wheel (setback and barricade distances from the ground)
• the crane's load chart / lift plan for reference
• flashlight

Steps

1. 1. Check in with the lift director / crane operator; confirm scope, don PPE, and confirm you observe-and-document from a safe distance only, you never rig, signal, level, or direct the lift (Subpart CC reserves these for the qualified rigger / signal person / operator).
2. 2. Ground & setup: photograph and document firm/drained/level ground, full outrigger/stabilizer extension with pads/cribbing, and the crane's level indication (§§1926.1402/.1404).
3. 3. Power-line clearance: identify overhead lines and confirm the planned swing/boom keeps the Table A minimum approach distance (default 20 ft for lines ≤350 kV) or that a documented de-energize / encroachment-prevention plan is in place (§1926.1408).
4. 4. Swing radius / crush zone: confirm the area swept by the rotating superstructure (counterweight) is barricaded to keep workers out (§1926.1424).
5. 5. Personnel & rigging: confirm a qualified signal person + an agreed signal method, a qualified rigger, the load chart / rated capacity posted, and slings/shackles/hooks (with safety latches) in serviceable condition per the rigger's inspection (§§1926.1419/.1425/.1428).
6. 6. For each finding, mark the condition against the Subpart CC checklist item, assign a tier (stop-work / correct-before-proceed / monitor), and name the responsible lift director / qualified operator.
7. 7. Enter photos, GPS/address, the checklist, and the tiered findings; sign. Route stop-work items to the lift director / operator with a timestamp, never direct or signal the lift.

What counts as done

• Ground/outrigger setup photographed
• Overhead power-line clearance and swing-radius barricading confirmed and photographed
• Qualified signal person + rigger + posted load chart + serviceable rigging documented
• GPS / address confirm
• Tiered findings list routed to the lift director

Proof is measured against these, not judged by taste.