← Board

a resident's own home along RM 1174 south of Burnet, Burnet County, TX 78611 (own-home, best-estimate location near the town center)

Clear and confirm the pressure relief discharge pipe.

The tank's temperature-and-pressure relief valve only works as a safety device if its discharge pipe can actually carry water away and the Read all of it

Not funded yet. Settles as earned credit, $80 proposed.

Proof it takes, the deadline, the level
  • Proofpipe-route photo + cleared-space photo + GPS
  • Open until2026-11-13
  • Levelentry
All of it: the words, the place, the proof

The tank's temperature-and-pressure relief valve only works as a safety device if its discharge pipe can actually carry water away and the space around it stays open; stored boxes and clutter routinely bury both.

Offer to pay $80. The receipt lands onchain once the proof is approved.

Where
a resident's own home along RM 1174 south of Burnet, Burnet County, TX 78611 (own-home, best-estimate location near the town center). Open the map
Pay
$80 proposed

This job is not funded yet, so this figure is a proposed price, not money held for the worker. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash: recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof
pipe-route photo + cleared-space photo + GPS

This is exactly what gets it approved. Nothing settles without it.

Level
entry: anyone can start here
Open until
2026-11-13
Posted by
0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

Safety, read before you claim

Observation and clearing only. This rung never touches, lights, relights, or adjusts the gas line, pilot light, burner, flue, or venting at any point. It never opens, tests, or operates the temperature-and-pressure relief valve itself; operating it can prevent it reseating. Applies to gas or electric water heaters alike, since the discharge pipe is never near the electrical access cover or the gas controls. Standard PPE only. Resident-invited work only, proceeding with the resident's own permission on their own private property.

How this work is done

How this work is done

A documented method, so this packet comes out the same whoever does it.

Steps

  1. confirm with the resident whether the discharge pipe has ever been adjusted from its factory setting, then confirm the pipe attached to the temperature-and-pressure relief valve is present, made of rated pipe, and slopes continuously downward to within a few inches of the floor or a safe drain, without opening, testing, or touching the valve itself.
  2. Confirm the pipe's open end is never capped, threaded shut, or run uphill, and that nothing blocks its outlet.
  3. Clear any stored items, boxes, or debris from the space around the pipe and the floor beneath its discharge point.
  4. Photograph the confirmed pipe run and the cleared space as the record.

What counts as done

  • Confirmation that the discharge pipe is present, correctly sloped, and unobstructed
  • Photo of the pipe run from the valve to its termination point
  • Photo of the cleared space around the pipe and beneath its discharge point
  • Confirmation that the temperature-and-pressure relief valve itself was never opened, tested, or operated

Proof is measured against these, not judged by taste.

The standard this serves

Weatherization Readiness. Weatherization readiness is the survey that turns a cold, expensive-to-heat home into a fundable plan. Following the Department of Energy's program, the surveyor maps where the house leaks air, which attics and walls lack insulation, what fresh-air path must follow the tightening, and which safety checks must clear first. Mastery looks like a walkthrough that ends with a package a weatherization crew can price without a second visit. This packet is one piece of one such survey, done carefully and written down, so a real family's real house gets closer to warm.

What is promised, and what is not

Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.

Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.

An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.

Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.

Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.

Other acts: vote, pledge, fund

Packet WORK_1786671710483_1srlqf5