Retrofit the resident's own well-pump motor to high efficiency with a VFD, a resident's own home, Leakey, TX (Real County).

This resident's own well-pump motor runs constant-speed well below its rated efficiency, burning real electricity against every irrigation and household draw; swapping in a high-efficiency motor with a variable-frequency drive matches output to actual demand and cuts that draw immediately.

Where

a resident's own home, Leakey, TX 78873 (Real County; best-estimate location, exact address not confirmed) · Open the map

Pay

$240 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash. You see which before you claim, never after.

Proof

licensed-electrician lockout/permit record + before/after nameplate photos + commissioning sheet + post-retrofit amperage re-test + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-09-28

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Steps

1. 1. Confirm the resident's permission and the pump's current nameplate rating, and photograph the existing motor before work.
2. 2. Licensed electrician de-energizes and locks out/tags out the circuit before any motor or panel work; never service an energized panel.
3. 3. Install the high-efficiency motor and variable-frequency drive, matching nameplate and drive parameters to the well's rated flow.
4. 4. Restore power, commission the drive, and photograph the running pump with a post-retrofit amperage reading.

What counts as done

• Licensed-electrician lockout-tagout record for the motor swap
• Before photo of the old constant-speed motor nameplate
• Confirmation that the new high-efficiency motor and VFD were commissioned to the well's rated flow
• Post-retrofit amperage reading showing the reduced electrical draw at matched output

Proof is measured against these, not judged by taste.

The standard this serves

Energy Efficiency Audit. Energy efficiency work begins with the walkthrough audit, the kind the ASHRAE standard describes: a trained eye moving through a building, reading the bills, the walls, the lights, and the equipment, and coming out with the short list of fixes worth doing first. Mastery looks like an auditor who can feel where a building is bleeding money within the hour, and prove it on paper. That instinct is trained by repetition on real buildings. This packet is one repetition: one system observed, one reading taken, one finding recorded the way the standard asks.