the public library serving Glen Rose, TX, near the town center, Glen Rose, TX 76043 (Somervell County; best-estimate location near the town center, branch name and hours to be confirmed with library staff, exact address not confirmed)
Replace the faded bird-safe window markers before they stop working, the public library serving Glen Rose, TX.
Sun and weather fade and lift exterior markers over a season; an unmaintained pattern is decoration, not protection. Read all of it
Not funded yet. Settles as earned credit, $80 proposed.
Proof it takes, the deadline, the level
- Proofbefore/after refresh photos + spacing confirm + replaced-count + GPS
- Open until2026-11-13
- Levelentry
All of it: the words, the place, the proof
Sun and weather fade and lift exterior markers over a season; an unmaintained pattern is decoration, not protection. This rung revisits the pattern already installed on a ground-floor reading-room window facing the parking lot at the public library serving Glen Rose, TX in Glen Rose, TX and puts it back to full working spacing.
Offer to pay $80. The receipt lands onchain once the proof is approved.
Safety, read before you claim
Every marker in this pattern goes on the OUTSIDE surface of the glass, never the inside. An interior decal does almost nothing, because it is the exterior surface that reflects sky and vegetation back at an approaching bird; this rung is never satisfied by anything applied to the inside of the pane. The working spacing across the whole pane is no more than about 2 inches apart horizontally and 4 inches apart vertically, corner to corner. A single silhouette or a handful of scattered marks does nothing, since a bird simply flies through the gap around them; spacing across the full pane, not a mark count, is what actually stops a strike. Ground-floor windows only, reachable from the ground or a step stool. If a window sits above the first story or needs a ladder or roof access to reach, this rung does not apply and that window is out of scope. Nothing in this rung cuts, drills, or otherwise alters the window glazing, sash, or frame, and no film is ever applied between the panes. Markers attach to the exterior glass with an adhesive or suction mount meant to come off without damage; a netting frame attaches to the existing window trim or the adjacent wall, never to the glass itself. If a bird is ever found stunned, injured, or dead at or near this window during this work, it is left alone and never handled. If it needs help, the only contact is a licensed wildlife rehabilitator; this worker never picks up, moves, or treats a bird. This Texas Hill Country ground work happens in early morning or evening when possible, never a hot midday session; water is carried with hydration breaks every 20 minutes. Hand tools only: tape measure, level, adhesive applicator, screwdriver, and a step stool at most; no power tools of any kind on this rung.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Steps
- 1. Confirm with library staff how the marker pattern since it was installed is currently handled, then act.
- 2. Walk the pane and note every marker that has faded past visibility, lifted, or fallen off.
- 3. Replace or reapply markers at the original grid points on the OUTSIDE glass surface until no gap exceeds 2 inches horizontally or 4 inches vertically.
- 4. Photograph the refreshed pattern from outside and record how many markers were replaced.
What counts as done
- Confirmation of library staff permission and coordination on site
- Before photo showing faded or missing markers
- After photo of the refreshed exterior pattern
- Confirmation that the refreshed spacing does not exceed 2 inches horizontally or 4 inches vertically anywhere on the pane
- Count of markers replaced or reapplied
- Site record: the exact site's name and street address, and the contact who agreed to the work
Proof is measured against these, not judged by taste.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.
Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1786674786543_yl0oir5