Electrification retrofit readiness survey: heat-pump + panel, Albuquerque.

A household in Albuquerque wants to move off gas heat but has no idea whether the panel and insulation can support a heat pump.

Where

Residential retrofit site, Albuquerque NM · Open the map

Pay

$584 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

photo inventory (HVAC/water fuel+age, panel label, insulation) + GPS + panel amperage/spare-slot count + ranked heat-pump readiness list, all routed to licensed pros

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-08-26

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• tablet/clipboard with the readiness checklist
• camera
• tape measure
• flashlight (panel/attic/crawl)
• note on existing HVAC + water-heating fuel and age
• thermal/IR camera (optional, insulation scope)

Steps

1. 1. Confirm the address + scope with the owner/occupant and arrange access to the mechanical room, electrical panel, and attic/crawl. Observe-and-document only: no panel or HVAC work.
2. 2. Inventory existing space + water heating: fuel (gas/electric/oil/propane), system type + age, ducted vs. ductless suitability, and any combustion appliance present (for later decommission planning by a pro).
3. 3. Photograph the electrical panel label: main service amperage, panel make, and count of used vs. spare breaker slots; note obvious constraints (full panel, subpanels, aluminum branch wiring), as inputs for a licensed electrician's load calc, NOT a load calc yourself.
4. 4. Record the envelope/insulation baseline: attic/wall/floor insulation presence + approximate R-level where visible, and obvious air-leakage points; use IR imaging if available.
5. 5. Assemble a heat-pump readiness summary: what a conversion would likely require (panel capacity, dedicated circuit, ducting/ductless, envelope improvements) as a ranked readiness list, framed as inputs for licensed pros, not a design.
6. 6. Enter photos, GPS/address, the inventory, panel observations, insulation baseline, and the ranked readiness list; sign. Route panel/service and combustion-decommission questions to licensed pros.

What counts as done

• Photos of existing heating/water-heating systems with fuel + type + age
• Photo of the electrical panel label with service amperage + used/spare breaker slots recorded (observation, not a load calc)
• Insulation/air-sealing baseline (levels where visible, obvious leakage points)
• GPS / address confirm
• Ranked heat-pump readiness list framed as inputs for a licensed electrician / mechanical contractor

Proof is measured against these, not judged by taste.