Install a dog-waste bag-and-bin station, station 2 -- Ted Watkins Memorial Park, 1335 E 103rd St, Los Angeles, CA 90002.

Dog owners walking this park's open lawn have nowhere to get a waste bag or dispose of one, so uncollected waste piles up along the walking paths; an anchored, weatherproof bag dispenser and lidded bin fixes that at each entrance.

Where

Ted Watkins Memorial Park, 1335 E 103rd St, Los Angeles, CA 90002 · Open the map

Pay

$580 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + anchor photo + bag-dispenser stock photo + lidded-bin liner confirm + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-19

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• right-of-way or parks permit + the 811 utility-locate confirmation
• the asset kit with its manufacturer anchoring instructions and specified anchors
• rotary hammer or drill with the anchor-spec bit, plus dust extraction or a wet method
• torque wrench set to the anchor spec + 2-ft level + tape measure
• cones or barricades and a maintained pedestrian path
• camera + GPS phone

Steps

1. 1. ASSESS: photograph the location as found, confirm the permit covers this exact placement, and confirm the 811 locate is honored and marked before any drilling or digging.
2. 2. Set cones or barricades and keep a walkable path around the work; never work from a traffic lane.
3. 3. Mark the anchor pattern from the manufacturer's template, and check the clear width left for the accessible route (36 in minimum) before a single hole is drilled.
4. 4. Drill and set the specified anchors with dust control, then place the asset and bring every fastener to the manufacturer's torque value.
5. 5. VERIFY: level check on the seat, top rail or post; torque-check each anchor and record the value; confirm the asset does not block the accessible route or a curb ramp landing.
6. 6. Photograph the finished install from the same vantage as the before photo, log the anchor torque and the permit reference, and enter both in the proof record.

What counts as done

• Before photo of the bare entrance/path with no station
• After photo of the installed, anchored post with bag dispenser and lidded bin
• Bag-dispenser stocked and refill instructions photographed
• Lidded bin fitted with a liner and confirmed animal-resistant closure

Proof is measured against these, not judged by taste.