Cut overwintered perennial stems to graduated nesting heights.

The stand of coneflower and ironweed stems this park deliberately left standing through winter is now due for its spring cut, and cutting it the way the rest of the park gets cut -- flush to the ground with a string trimmer -- would remove the exact hollow stubs this season's stem-nesting bees are about to start using. Hand-cutting the stand to a graduated range of heights instead, tallest for the thickest stems, keeps usable nesting stubs standing while still clearing the bed for new growth.

Where

a public park pollinator bed with an overwintered stand of perennial stems due for spring management, Graham, TX 76450 (Young County); best-estimate location near the town center, exact address not confirmed · Open the map

Pay

$90 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + height range recorded + active-stub confirmation + cut-tops-left-on-site confirmation + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-19

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Steps

1. 1. In early-to-mid spring before that season's new growth has taken over the bed, walk the marked stand and check any prior-year cut stubs for a plugged, capped end (mud, leaf-piece, or resin seal) -- a sign of an active occupant; do not disturb any stub showing a plugged end.
2. 2. Cut this stand's standing dead stems to a graduated range of heights, roughly 8 to 24 inches from the ground, using hand pruners or loppers -- wider-diameter stems left taller, thinner stems cut shorter -- leaving hollow or pithy stubs standing rather than cutting to the ground or leaving the stand uncut.
3. 3. Leave the cut stem tops loosely piled at the edge of the same bed rather than hauling them away or chipping them, since bees that were already using the cut portion may still need to emerge from it.
4. 4. Check stubs left standing from two seasons prior; retire (cut flush and compost) only the ones showing no plugged or occupied ends, clearing space for this year's cut without disturbing anything still active.
5. 5. Photograph the finished, graduated-height stand from the same before vantage and record the height range actually used.

What counts as done

• Before photo of the uncut winter stand
• After photo of the stand cut to graduated heights, with the height range recorded
• Confirmation that no plugged or active-looking stub was disturbed
• Confirmation that cut stem tops were left on-site rather than hauled away or chipped
• Confirmation that only stubs from two-plus seasons prior, showing no occupancy, were retired

Proof is measured against these, not judged by taste.