Build and mount a roofed frame with removable cavity-nesting bee units, a resident's own home, Kilgore, TX.

This resident bought a pre-drilled wooden bee-block from a garden store two years ago and it has sat on the same post since, never cleaned or replaced, with visible mold staining around several of the holes. Replacing it with a roofed frame built around removable paper-tube units -- rather than another version of the same fixed-block problem -- gives this yard cavity-nesting habitat that can actually be rotated instead of quietly degrading in place.

Where

a resident's own home near the town center, Kilgore, TX 75662 (Gregg County); best-estimate location, exact address not confirmed; a home with a post, fence, or wall suited to a low-mounted nesting frame, replacing an old fixed-block bee hotel · Open the map

Pay

$140 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + removable-unit confirmation + install date/unit type recorded + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-10

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Steps

1. 1. Build or source a small roofed frame (roughly 12 by 12 by 8 inches, open-fronted, with an overhanging roof to shed rain) sized to hold a set of small-diameter nesting units -- never a solid block with holes drilled directly into it.
2. 2. Load the frame with removable nesting units only: paper-tube liners inside reed or cardboard sleeves, or thin wood trays that slide out by hand. Confirm the removable design by pulling one loaded unit out by hand before mounting.
3. 3. Mount the frame at a reachable height (about 3 to 5 feet) on a post or wall bracket, facing morning sun (east or southeast) and sheltered from prevailing rain, using hand tools only.
4. 4. Record the install date and the nesting-unit type and tunnel diameter offered -- this date sets the rotation schedule, since units are due for replacement after roughly one to two nesting seasons.
5. 5. Photograph the finished, mounted, loaded frame from the matching before vantage, including one unit pulled partway out to show the removable design.

What counts as done

• Before photo of the bare mount site
• After photo of the mounted, loaded frame
• Photo confirming a nesting unit releases from the frame by hand, without tools
• Install date and nesting-unit type/tunnel diameter recorded
• Confirmation no unit was drilled directly into the frame as a fixed, non-removable block

Proof is measured against these, not judged by taste.