Seal the attic-bypass air leaks.

Once the gutters run clear, the next heat loss on this block is invisible: warm air riding top-plate gaps, wiring chases and the attic hatch straight into the Haughville winter. Foam-sealing those bypasses is the first real Energy-Petal repair on the ladder.

Where

1400-1500 block of W Michigan Street, Haughville, Indianapolis, IN 46222 · Open the map

Pay

$300 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos of each sealed bypass + GPS + materials note

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-30

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• caulk gun + backer rod
• low-expansion spray-foam sealant (fire-rated where required)
• storm window/door kit or rigid-foam rim-joist batts
• heat-tape + pipe-insulation sleeves (freeze-protection runs)
• camera
• tape measure + utility knife

Steps

1. 1. Confirm the scope with the occupant/facility manager against the readiness survey's ranked target list (or a fresh walk if none exists); photograph the untreated bypass, window, rim-joist run or pipe run.
2. 2. Prep the surface: clean and dry the substrate, remove failed old caulk or weatherstripping, and clear any debris blocking the install.
3. 3. Install the sealing/insulation material to the target's spec -- storm window/door, spray-foam bypass seal, rim-joist rigid-foam batt, or heat-tape plus pipe-insulation sleeve -- per manufacturer instructions.
4. 4. Verify the result (smoke-pencil/hand check for bypass work, fit-and-lock check for storm windows/doors, continuous-coverage check for rim-joist or pipe insulation) and photograph the finished install from the same vantage.
5. 5. Note any combustion-safety or moisture flag surfaced during the install and route it to a BPI-qualified pro before continuing to the next target.

What counts as done

• Photo of each bypass (top plate, chase, hatch) before sealing
• Photo of each bypass after sealing from the same vantage
• Materials note: sealant type + count of bypasses sealed

Proof is measured against these, not judged by taste.