Anchor a bike rack.

People who bike through North Hollywood, CA lock up to fences for lack of a real rack. An anchored inverted-U rack at a public right-of-way in North Hollywood, CA gives them somewhere safe.

Where

North Hollywood, CA (public right-of-way, exact site not yet named) · Open the map

Pay

$360 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

811 locate confirm + before/after photos + anchor-torque check + clearance measurement + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-30

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• right-of-way or parks permit + the 811 utility-locate confirmation
• the asset kit with its manufacturer anchoring instructions and specified anchors
• rotary hammer or drill with the anchor-spec bit, plus dust extraction or a wet method
• torque wrench set to the anchor spec + 2-ft level + tape measure
• cones or barricades and a maintained pedestrian path
• camera + GPS phone

Steps

1. 1. ASSESS: photograph the location as found, confirm the permit covers this exact placement, and confirm the 811 locate is honored and marked before any drilling or digging.
2. 2. Set cones or barricades and keep a walkable path around the work; never work from a traffic lane.
3. 3. Mark the anchor pattern from the manufacturer's template, and check the clear width left for the accessible route (36 in minimum) before a single hole is drilled.
4. 4. Drill and set the specified anchors with dust control, then place the asset and bring every fastener to the manufacturer's torque value.
5. 5. VERIFY: level check on the seat, top rail or post; torque-check each anchor and record the value; confirm the asset does not block the accessible route or a curb ramp landing.
6. 6. Photograph the finished install from the same vantage as the before photo, log the anchor torque and the permit reference, and enter both in the proof record.

What counts as done

• Before photo of the bare sidewalk clear zone
• 811 locate reference before any anchor drilling
• After photo of the installed, level, securely anchored rack
• Clearance measurement confirming the required pedestrian through-path remains open

Proof is measured against these, not judged by taste.