Repair a loose, cracked bench.

The bench at this corridor's small pocket plaza has a cracked slat and a wobbling leg from years of hard use -- the one place people can sit down along this stretch is one bad sit-down away from injuring someone; re-anchoring the frame and swapping the cracked slat makes it safe to sit again.

Where

the Broadway corridor, South Los Angeles, CA 90003 · Open the map

Pay

$260 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + anchor/leg-stability check + slat-fastener check + load-sit test + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-30

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• right-of-way or parks permit + the 811 utility-locate confirmation
• the asset kit with its manufacturer anchoring instructions and specified anchors
• rotary hammer or drill with the anchor-spec bit, plus dust extraction or a wet method
• torque wrench set to the anchor spec + 2-ft level + tape measure
• cones or barricades and a maintained pedestrian path
• camera + GPS phone

Steps

1. 1. ASSESS: photograph the location as found, confirm the permit covers this exact placement, and confirm the 811 locate is honored and marked before any drilling or digging.
2. 2. Set cones or barricades and keep a walkable path around the work; never work from a traffic lane.
3. 3. Mark the anchor pattern from the manufacturer's template, and check the clear width left for the accessible route (36 in minimum) before a single hole is drilled.
4. 4. Drill and set the specified anchors with dust control, then place the asset and bring every fastener to the manufacturer's torque value.
5. 5. VERIFY: level check on the seat, top rail or post; torque-check each anchor and record the value; confirm the asset does not block the accessible route or a curb ramp landing.
6. 6. Photograph the finished install from the same vantage as the before photo, log the anchor torque and the permit reference, and enter both in the proof record.

What counts as done

• Before photo of the cracked slat/wobbling leg
• Anchor and leg-stability check confirming no movement after re-securing
• After photo of the repaired bench with the replaced slat
• Load-sit test (a person sits, no shift or creak) confirmed and photographed

Proof is measured against these, not judged by taste.