Document moisture and possible mold signs inside a home along the corridor, household 2 -- the Grayson Community Services District corridor near Laird Street / River Road, Grayson, CA 95363.

This home sits low in the San Joaquin River floodplain and has taken on seasonal dampness after past storm events; no careful document-only walk-through has ever mapped where the moisture is coming from before a licensed contractor is called.

Where

the Grayson Community Services District corridor near Laird Street / River Road, Grayson, CA 95363 · Open the map

Pay

$180 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

photo of each stain/damp area from the doorway + written moisture-source note + completed readiness checklist naming the licensed-contractor follow-on + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

entry

Open until

2026-09-30

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• camera
• pin/pinless moisture meter
• hygrometer (indoor relative humidity by room)
• flashlight (attic/crawl/basement/under-sink)
• tape measure (visible-mold extent vs the EPA 10-sq-ft threshold)
• N95 respirator + nitrile gloves (surveyor protection, no disturbance)

Steps

1. 1. Start with the household's experience: where it smells musty, who has symptoms, when it started, what flooding/leak history the home has. Their answers target the survey: this is their claim of a dry, breathable home.
2. 2. Hunt moisture sources room by room and in attic/crawl/basement: active leaks (roof, plumbing, windows), condensation surfaces, grade/drainage problems at the foundation, bath/kitchen/dryer exhaust termination, and HVAC condensate; photograph each and take moisture-meter readings at suspect assemblies.
3. 3. Record indoor relative humidity by room (target <60%, ideally 30-50% per EPA) and note dehumidification or ventilation gaps.
4. 4. Document visible mold WITHOUT disturbing it: location, surface/material, and measured extent per patch, classed against the EPA threshold (under ~10 sq ft = careful DIY-cleanable per EPA guidance; over = professional remediation).
5. 5. Build the moisture-first sequence: fix the water FIRST (each source mapped to the right trade: roofer, plumber, drainage), then dry, then remediate, then rebuild; mark what the household can safely do (small-area cleanup per EPA steps, humidity control) vs what routes to pros.
6. 6. Enter photos, GPS/address, the moisture-source map, humidity/moisture readings, the mold extent inventory, and the sequenced plan; sign. Real (found and measured), Proven (photo+GPS+signature), One-of-one (this home's water, this family's air).

What counts as done

• Photo of each stain, damp patch or musty area, taken from the doorway or room entrance
• Written note of the likely moisture source (leak, condensation, drainage) where visible without disturbing anything
• Completed readiness checklist naming the licensed mold-remediation contractor as the physical-work follow-on
• GPS / address confirm

Proof is measured against these, not judged by taste.