Repair the park perimeter fence gate.

A perimeter fence gate at Lost Hills Park no longer latches, leaving the splash pad and playground area open to the adjacent road at hours the park is meant to be closed.

Where

Lost Hills Park, Lost Hills, CA 93249 · Open the map

Pay

$190 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

before/after photos + latch-function test + hinge-security check + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-09-30

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• the 811 utility-locate confirmation + the owner or agency work authorization
• replacement posts, pickets, fabric or fencing per the agency's spec, plus ties and fasteners
• post-hole tool or driver, hand mallet, fence stretcher or tensioning tool
• string line, level, tape measure
• gloves, eye protection and hearing protection where a driver is used
• camera + GPS phone

Steps

1. 1. Photograph the fence run as found, and record what failed (leaning or broken posts, cut or slack fabric, a gate that will not latch) with counts.
2. 2. Confirm the owner or agency authorization for this run, and confirm the 811 locate is honored and marked before any post hole is opened.
3. 3. Set a string line along the intended fence line so the repair follows the original alignment and does not creep onto a neighboring parcel.
4. 4. Reset or replace the failed posts to the agency's specified depth, and replace broken pickets or fabric with the specified material.
5. 5. Tension the run to the specified tension and rehang or adjust the gate so it swings and latches through its full travel.
6. 6. VERIFY: confirm the finished line is plumb and straight against the string, the gate latches, and no sharp wire end or protruding fastener is left in public reach.
7. 7. Photograph the repaired run from the before vantage, log the post and picket counts, and enter them in the proof record.

What counts as done

• Before photo of the non-latching gate
• Latch-function test video after repair
• Hinge-security photo confirming secure, aligned hardware
• After photo of the repaired, latching gate

Proof is measured against these, not judged by taste.