Retrofit a dark alley light fixture, fixture 2 -- the Garey Ave corridor, Pomona, CA 91766.

A cobra-head alley light behind this corridor's storefronts has failed, leaving the service alley dark for the workers and delivery crews who use it after close; retrofitting the fixture with a new photocell-controlled LED head restores a real, working light at that corner.

Where

the Garey Ave corridor, Pomona, CA 91766 · Open the map

Pay

$600 proposed

This packet is not funded yet, so this figure is a proposed price and not money waiting in escrow. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash — recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

lockout/tagout confirm + before/after photos + photocell function test (dusk/dawn) + fixture-mount torque check + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

advanced

Open until

2026-10-16

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

How this work is done

A documented method, so this packet comes out the same whoever does it.

Bring

• electrical permit + the licensed electrician of record + the honored 811 locate
• the specified fixture with its IES photometric and BUG rating, plus pole, base and anchor hardware
• footing materials, forms and a plumb-setting jig
• torque wrench, multimeter, and lockout/tagout hardware for any circuit tie-in
• traffic control for the work zone plus hi-vis apparel to ANSI/ISEA 107
• camera + GPS phone + a light meter for the after reading

Steps

1. 1. ASSESS: photograph the location as found, take a night-time light-level reading at the gap, and confirm the permit, the fixture specification and the honored 811 locate.
2. 2. Set the work zone and, for any tie-in to an existing circuit, apply lockout/tagout and verify the circuit is dead with a meter before touching a conductor.
3. 3. Excavate and form the footing to the pole manufacturer's depth and diameter, keeping clear of every marked utility; stop and reschedule if a mark appears inside the footing.
4. 4. Set the base and anchor bolts plumb, let the footing reach the specified strength, then raise the pole and torque the anchor nuts to the manufacturer's value.
5. 5. Make the electrical connections to NEC Article 410/411 under the licensed electrician of record, and confirm grounding and bonding before energizing.
6. 6. VERIFY: after dark, take a light-level reading at the same point as the before reading and confirm the fixture's BUG rating holds (no uplight, no trespass onto the adjacent property).
7. 7. Photograph the finished install and the night reading, log the permit, the torque values and the inspection reference, and enter them in the proof record.

What counts as done

• Before photo of the dark/failed fixture
• Lockout/tagout confirmation before opening the fixture or pole base
• After photo of the installed LED head with new photocell
• Photocell function test confirming the light switches on at dusk/off at dawn (or a covered-sensor simulation)

Proof is measured against these, not judged by taste.