Aldama
Anchor a bike rack.
Install an anchored inverted-U bike rack at a public right-of-way in Los Angeles, CA. Read all of it
Not funded yet. Settles as earned credit, $360 proposed.
Proof it takes, the deadline, the level
- Proofbefore/after photos + anchor-bolt log + GPS
- Open until2026-10-29
- Levelintermediate
All of it: the words, the place, the proof
Install an anchored inverted-U bike rack at a public right-of-way in Los Angeles, CA. People who bike through here lock up to fences for lack of a real rack, and an anchored rack gives them somewhere safe.
Fund it for $360. Proof lands onchain when it's done.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Bring
- right-of-way or parks permit + the 811 utility-locate confirmation
- the asset kit with its manufacturer anchoring instructions and specified anchors
- rotary hammer or drill with the anchor-spec bit, plus dust extraction or a wet method
- torque wrench set to the anchor spec + 2-ft level + tape measure
- cones or barricades and a maintained pedestrian path
- camera + GPS phone
Steps
- 1. ASSESS: photograph the location as found, confirm the permit covers this exact placement, and confirm the 811 locate is honored and marked before any drilling or digging.
- 2. Set cones or barricades and keep a walkable path around the work; never work from a traffic lane.
- 3. Mark the anchor pattern from the manufacturer's template, and check the clear width left for the accessible route (36 in minimum) before a single hole is drilled.
- 4. Drill and set the specified anchors with dust control, then place the asset and bring every fastener to the manufacturer's torque value.
- 5. VERIFY: level check on the seat, top rail or post; torque-check each anchor and record the value; confirm the asset does not block the accessible route or a curb ramp landing.
- 6. Photograph the finished install from the same vantage as the before photo, log the anchor torque and the permit reference, and enter both in the proof record.
What counts as done
- Before photo of the site
- Anchor-bolt installation log
- After photo of the finished rack
Proof is measured against these, not judged by taste.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment that backs the wage. Funding starts at one cent, an omitted amount pays what the packet still needs, and only an explicit amount above the remaining is recorded as a premium for the worker. Money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1789355996108_obs8ch8","funderWallet":"0xYOU"}.
Open, but not claimable yet. restricted: permit-required — Regulated or permit-required work cannot be claimed on this rail yet. It stays readable; voting and pledging are free, and funding is separate from claiming.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1789355996108_obs8ch8