Throop2016
Replace the gas furnace with a heat pump.
The gas furnace at a brick two-flat on the 2000 block of S Throop St, Pilsen, Chicago, IL 60608 burns fossil fuel Read all of it
Not funded yet. Settles as earned credit, $880 proposed.
Proof it takes, the deadline, the level
- Proofpermit + commissioning sheet + before/after photos + inspection result + GPS
- Open until2026-10-18
- Leveladvanced
All of it: the words, the place, the proof
The gas furnace at a brick two-flat on the 2000 block of S Throop St, Pilsen, Chicago, IL 60608 burns fossil fuel for every hour of Chicago winter heat; a cold-climate heat pump sized to the readiness survey is the Energy-petal repair, and it cools too.
Fund it for $880. Proof lands onchain when it's done.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Bring
- Manual J/S load calculation + approved permit
- heat-pump equipment (outdoor + indoor units), line set, pad/brackets, condensate handling
- refrigerant gauges/scale + vacuum pump + torque tools (EPA 608-certified technician)
- multimeter + thermometer/anemometer for commissioning airflow and delta-T
Steps
- 1. ASSESS: verify the Manual J/S sizing against the home (envelope, ductwork or head locations), confirm electrical capacity for the new circuit, and photograph the existing system and nameplates.
- 2. Decommission and recover refrigerant from the old system per EPA 608; remove equipment for lawful disposal/recycling and document it.
- 3. Set and mount the new equipment, run and braze/flare the line set, pull vacuum to spec, and release/weigh in charge per manufacturer; a licensed electrician lands the new circuit and disconnect.
- 4. Commission: verify airflow, refrigerant charge (subcooling/superheat per spec), heating and cooling delta-T, and condensate drainage; set up controls/thermostat.
- 5. VERIFY: pass the mechanical/electrical inspection; record commissioning numbers and before/after photos; leave the owner the manual, warranty registration, and maintenance schedule.
What counts as done
- Before photos incl. old-equipment nameplates + refrigerant-recovery record
- Commissioning sheet (vacuum, charge method, delta-T, airflow) confirming cold-climate performance
- Permit inspection pass reference
- After photos of the installed system and disconnect labeling
Proof is measured against these, not judged by taste.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment that backs the wage. Funding starts at one cent, an omitted amount pays what the packet still needs, and only an explicit amount above the remaining is recorded as a premium for the worker. Money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1789694299528_6q3jkjg","funderWallet":"0xYOU"}.
Open, but not claimable yet. restricted: permit-required, regulated. Regulated or permit-required work cannot be claimed on this rail yet. It stays readable; voting and pledging are free, and funding is separate from claiming.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1789694299528_6q3jkjg