the public roadside along the Lost Hills Oil Field fenceline, Lost Hills, CA 93249
Install a wind-fence dust barrier.
Install a wind-fence dust barrier at this field edge along the Lost Hills Oil Field fenceline, site 1. Read all of it
Not funded yet. Settles as earned credit, $210 proposed.
Proof it takes, the deadline, the level
- Proofbefore/after photos + post-spacing/anchor check + fabric-height log + GPS
- Open until2026-10-30
- Levelintermediate
All of it: the words, the place, the proof
Install a wind-fence dust barrier at this field edge along the Lost Hills Oil Field fenceline, site 1. The survey found this field edge with no windbreak, and fugitive dust crosses straight onto the public roadside and toward nearby homes every time the Valley's afternoon wind picks up.
Fund it for $210. Proof lands onchain when it's done.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Bring
- the 811 utility-locate confirmation + the owner or agency work authorization
- replacement posts, pickets, fabric or fencing per the agency's spec, plus ties and fasteners
- post-hole tool or driver, hand mallet, fence stretcher or tensioning tool
- string line, level, tape measure
- gloves, eye protection and hearing protection where a driver is used
- camera + GPS phone
Steps
- 1. Photograph the fence run as found, and record what failed (leaning or broken posts, cut or slack fabric, a gate that will not latch) with counts.
- 2. Confirm the owner or agency authorization for this run, and confirm the 811 locate is honored and marked before any post hole is opened.
- 3. Set a string line along the intended fence line so the repair follows the original alignment and does not creep onto a neighboring parcel.
- 4. Reset or replace the failed posts to the agency's specified depth, and replace broken pickets or fabric with the specified material.
- 5. Tension the run to the specified tension and rehang or adjust the gate so it swings and latches through its full travel.
- 6. VERIFY: confirm the finished line is plumb and straight against the string, the gate latches, and no sharp wire end or protruding fastener is left in public reach.
- 7. Photograph the repaired run from the before vantage, log the post and picket counts, and enter them in the proof record.
What counts as done
- Before photo of the unshielded field edge
- Post-spacing and anchor-depth photo
- Fabric-height log matched to the field-edge wind exposure
- After photo of the installed wind fence/dust barrier
Proof is measured against these, not judged by taste.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment that backs the wage. Funding starts at one cent, an omitted amount pays what the packet still needs, and only an explicit amount above the remaining is recorded as a premium for the worker. Money settles only on accepted proof. An agent can fund it in one x402 call: POST /nurture/fund {"workId":"WORK_1790789950182_7xiphai","funderWallet":"0xYOU"}.
Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1790789950182_7xiphai