the street-facing wall of an apartment building on the 600 block of S Alvarado St, Los Angeles, CA 90057
Remove graffiti and repaint the street-facing wall of an Alvarado Street building.
A worker in a hi-vis vest, goggles and chemical gloves rolls matched paint over a tag on a street-facing wall of an apartment building in Los Angeles; the paint covers the tag and matches the wall. Read all of it
Not funded yet. Settles as earned credit, $220 proposed.
Proof it takes, the deadline, the level
- Proofbefore/after photos + paint-match note + GPS
- Open until2026-12-25
- Levelentry
All of it: the words, the place, the proof
Clean off the graffiti and repaint the street-facing wall of the apartment building on S Alvarado St in Los Angeles. Tagging there has gone unaddressed for weeks, which invites more of it, and a same-color finish keeps the block's frontage looking cared for. For the payer: - Price: $220 per wall of up to 200 square feet. Basis: two workers for about two hours at about $45 an hour each plus remover, matched paint and supplies; proposed, to verify against the owner's quote. - Likely payer: The building's owner or manager, who gives the written consent. - No license is needed. - No permit is needed; the owner's or manager's written consent for the wall.
Offer to pay $220. The receipt lands onchain once the proof is approved.
Safety, read before you claim
After the crew's orientation, owner or manager consent is required and the remover's label comes first. Never treat a surface without it; use low-VOC exterior paint, roll from the ground only, and ventilate near open windows or doors; wear boots, gloves and eye protection.
The full safety list for this job:
- Gear, Title 8 sections 3385 and 3384: closed-toe boots for remover spills and dropped containers; chemical-resistant gloves for solvent removers, which burn skin and soak through cloth; match the glove to the label.
- Wildfire smoke, section 5141.1: at a PM2.5 AQI of 151 or more the employer provides N95 respirators for voluntary use and moves the work indoors or cuts exposure where feasible; above AQI 500 respirators are required under a respiratory protection program.
- Heat, section 3395: drinking water, shade and cool-down rests; shade is ready at 80 F and the high-heat steps start at 95 F.
- Orientation, section 3203: the crew's injury and illness prevention program orientation comes before any work.
- The remover's label and safety data sheet are read before it is opened (Title 8 section 5194).
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Bring
- graffiti remover/solvent OR matched paint-out paint + roller/brush
- pressure washer (masonry-safe setting) where applicable
- gloves + eye protection
- camera
Steps
- 1. ASSESS: photograph the tagging and identify the surface material (brick, painted metal, glass, painted wood) to choose a safe removal method that won't damage the substrate.
- 2. Confirm property-owner/manager consent for the specific wall or gate before any solvent, paint or pressure-washing touches the surface.
- 3. Apply the matched method (masonry-safe solvent and rinse, matched paint-out roll, or low-pressure wash) per the product's instructions, working from the least aggressive method first.
- 4. Photograph the cleaned surface from the same before vantage and note the method used for future reference on that surface.
What counts as done
- Before photo of the tagged wall, with GPS and time
- After photo from the matching vantage, fully covered
- The paint color and sheen match noted, and the remover product if one was used
- The owner's or manager's written consent for the wall cited
- The MyLA311 service request number or the City work order this wall answers, copied from the request, or none when there is none
- Sign-off: the owner or manager signs off the finished work in writing. Write who signed and the date, or the date you asked.
- Count: square feet cleaned and repainted, written next to the photos.
- Wash water never reaches a storm drain: cover or berm every inlet downhill before any water runs, and carry captured water to the named disposal point.
Proof is measured against these, not judged by taste.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.
Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1794289259677_22rrgys