the 4400-4500 block of Clara St, Cudahy, CA 90201
Seal the drafts.
Seal these units' doors and windows on the Clara St block in Cudahy, CA with renter-appropriate weatherstripping. Read all of it
Not funded yet. Settles as earned credit, $85 proposed.
Proof it takes, the deadline, the level
- Prooflandlord-permission record + before/after photos per opening + compression check + door-sweep fit + latch/close confirm
- Open until2027-11-10
- Levelentry
All of it: the words, the place, the proof
Seal these units' doors and windows on the Clara St block in Cudahy, CA with renter-appropriate weatherstripping. They leak conditioned air at worn or poorly-set edges, driving up a renter's own utility bill even though the building belongs to a landlord who hasn't fixed it.
Offer to pay $85. The receipt lands onchain once the proof is approved.
Safety, read before you claim
After the crew's safety orientation, renter-appropriate work only: peel-and-stick or clip-on weatherstripping and a slip-on door sweep, nothing that alters the unit's fixtures, and do not force a binding sash. Tenant AND landlord or property-manager consent precede work; wear slip-resistant closed-toe shoes and nitrile gloves.
The full safety list for this job:
- Gear, Title 8 sections 3385 and 3384: slip-resistant closed-toe shoes for stepping up to reach and dropped tools; nitrile gloves for caulk, foam sealant and solvents.
- Orientation, section 3203: the crew's injury and illness prevention program orientation comes before any work.
How this work is done
How this work is done
A documented method, so this packet comes out the same whoever does it.
Steps
- Get written or recorded permission from the landlord or property manager, along with the tenant's consent, before starting, and save it for the proof record.
- Walk the units and pick each door and window that leaks at a worn or poorly set edge, then photograph each one before treating it.
- Peel off any worn weatherstripping by hand, then clean and dry the edge where the new strip will sit.
- Measure and cut peel-and-stick or clip-on weatherstripping to the length of each edge.
- Press the strip into place along each sash or door edge so it compresses evenly, and ease it back if the sash or door starts to bind.
- Slip a door sweep onto the bottom of each door and adjust it flush to the threshold so no daylight shows under it.
- Close and latch every treated door and window to confirm it still shuts and latches.
- Photograph each treated opening after the work and enter the permission record, before and after photos and the closing check in the proof record.
What counts as done
- Written or recorded landlord/property-manager permission for the tenant-facing work
- Before and after photos of each treated door/window
- Weatherstripping compresses evenly without binding the sash/door
- Door sweep fitted flush to the threshold with no daylight gap
- Every treated opening still closes and latches after installation
Proof is measured against these, not judged by taste.
The standard this serves
DIY Weatherization and Air Sealing. Air sealing is the cheapest energy work there is, and the Department of Energy has spent decades proving it: a tube of caulk and a roll of weatherstrip, placed where the cold actually comes in, beat almost any gadget you can buy. This standard keeps the work occupant-safe: no wiring, no combustion equipment, no disturbing old paint. Mastery looks like hands that can find a draft with a bare palm and close it for good. This packet is one home's worth of that: find the gaps, seal them, photograph the proof.
What is promised, and what is not
Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.
Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.
An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.
Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.
Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.
Other acts: vote, pledge, fund
Packet WORK_1794290359135_oo91glc