Install low-flow fixtures.

Replace this unit's standard-flow fixtures on the Clara St block in Cudahy, CA with WaterSense-rated aerators and showerheads. That cuts the tenant's water bill without changing how the household uses water or requiring any lease-altering work.

Offer to pay $95. The receipt lands onchain once the proof is approved.

What it looks like

A worker shuts off the supply valve and replaces a standard showerhead with a WaterSense low-flow showerhead at the 4400-4500 block of Clara St, then photographs the installed fixture with a camera.

A description of this kind of work, not a record that it happened here.

Where

the 4400-4500 block of Clara St, Cudahy, CA 90201. Open the map

Pay

$95 proposed

This job is not funded yet, so this figure is a proposed price, not money held for the worker. If a buyer funds it, approved proof settles that price onchain. If nobody funds it, approved proof earns provable credit toward the work instead of cash: recorded, and readable any time at vealth.net/labor/credit/(your wallet). You see which before you claim, never after.

Proof

landlord-permission record + before/after photos + flow-rate measurement + WaterSense label photo + GPS

This is exactly what gets it approved. Nothing settles without it.

Level

intermediate

Open until

2026-12-10

Posted by

0x034F…6c89

The creator wallet. Its signature is what approves proof and settles the wage.

Start after the crew's safety orientation. Close the fixture's own supply stop before opening it where one is in reach and turns freely (a showerhead is swapped with the shower valve off), and never turn a building main, meter, backflow-prevention or fire-line fitting or force a stop that weeps or will not close. Aerators and showerheads only, in nitrile gloves and eye protection, with cold water for flow tests; a toilet or any pipe or valve work is licensed plumbing, so stop and tell the owner; wear slip-resistant closed-toe shoes.

The full safety list for this job:

• Follow the manufacturer's installation instructions, and start only after the tenant AND the landlord or property manager consent.
• Shut off the supply valve before removing any fixture, and do not modify the building's main shutoff or meter.
• Old multi-turn stops often leak the first time they move in years: if one weeps, close the handle, stop, and report it to the owner. A showerhead has no supply valve of its own, so do not hunt for one; keep water from being pushed at the face. Test flow with cold water; hot lines scald and the water heater setting is the owner's. A swap says nothing about water quality, lead in old brass, or the pipes behind the wall; never call the water fit to drink. Wrap chrome in cloth or tape before gripping with a wrench. Hand every old part back to the owner in a bag.
• Orientation to the site's injury and illness plan before touching a fixture: who to call, where first aid is, what to stop for (Title 8 section 3203).
• Restrooms and closets run hot: water, a cool place to rest, watch each other for heat signs (use the outdoor heat plan, section 3395, for hose bibs and exterior fixtures) (Title 8 section 3396).
• Eye protection under a sink or overhead at a shower arm: scale and debris fall in the face (Title 8 section 3382).
• Wear gloves and closed-toe shoes (Title 8 section 3384).
• Footwear, Title 8 section 3385: slip-resistant closed-toe shoes for wet floors and dropped fixtures.
• Outdoors: wildfire smoke, section 5141.1: at a PM2.5 AQI of 151 or more the employer provides N95 respirators for voluntary use and moves the work indoors or cuts exposure where feasible; above AQI 500 respirators are required under a respiratory protection program.
• Outdoors: heat, section 3395: drinking water, shade and cool-down rests; shade is ready at 80 F and the high-heat steps start at 95 F.

Three separate acts, never one: a vote is a free signed preference that moves no money; a pledge is free signed backing intent, balance-checked, that moves no money and never marks the packet funded; funding is a real payment, made by the payer straight to the worker, with no Vealth fee. Paying Vealth is closed: Vealth takes no new card or wallet payment for a job. To fund a job, offer to pay the worker directly, then pay them yourself when you accept the proof, from your own wallet or by your own card or bank. From a wallet: prepare_token_offer, sign, submit_token_offer; after the proof is accepted you pay the worker on chain and the worker records it (prepare_token_settlement, or POST /labor/settle for USDC on Base). By card or bank: prepare_direct_offer, sign, submit_direct_offer; you pay the worker yourself and the worker records it with prepare_direct_settlement. Both are free, need no gas, and move no money through Vealth.

Claiming is free. You sign to prove the wallet is yours: no card, no deposit, no fee. Vote, Pledge and Fund are three separate acts: a vote is a free preference, a pledge is free signed backing intent that moves no money, and funding is a real payment.

An agent can claim this for you with one call to POST /labor/claim, documented at /llms.txt.

Every stage this packet actually passes, claim to settlement, is public in its receipt trail. A stage that has not happened is not claimed.

Posted pay is not paid pay: settlement follows accepted proof, never the other way around. Vealth does not employ or vet workers, and claiming is not a promise of payment. See how proof and receipts work.